User manual GRUNDIG YACHT BOY 400

[. . . ] WORLD RECEIVER YACHT BOY 400 YACHT BOY 400 TIME I SLEEP ON/OFF MHz 60 FM TUNING . . 5 . . . 3. . . 4. 0. . . 1. . . 2 89. 6 FREE SLEEP ON TIME TIME 1/2 STORE AUTO TUNING FM 1 2 3 MEMO AM 4 7 5 8 6 9 RESET 0 FREQU. /METER LOCK AUTO TUNING ST E P 40 STATION ES MEMORI SSB LW / M W / S W /FM STEREO SIZED PLL SYNTHE RSION DUAL CONVE Contents Contents Your Unit at a Glance Display . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 04 Front of Unit. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 06 Top of Unit . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . [. . . ] The buttons are thus protected against inadvertent operation (indication LOCK in display). To unlock the buttons, press the LOCK button once again. TIME I LOCK Display Illumination Pressing the ¶ LIGHT button switches on the display illumination for approx. If you press a button of the unit, this illumination time will be increased. If you wish to immediately switch off the display illumination, press the ¶ LIGHT button once again. I 8:0 0 BATT. CHECK TUNING 0. . . 1. . . 2. . . 3. . . 4. . . 5 FM LW MW SW 8. 9. 8. 6. 0 kHz MHz 13 General Operation Volume and Tone The volume is adjusted with the VOLUME control. HIGH = Treble. Waveband Selection After switching on the unit with the ¢ ON/OFF button, it is ready for reception and you hear the station last tuned to. The first pressure on the ¢ AM button switches to the station last received on one of the AM bands. Each further pressure on the bands in the order LW MW SW LW ¢ AM button steps through the AM etc. MW and you will hear the station last tuned to in the selected band. 14 Station Tuning Switch the unit on with the ¢ ON/OFF button. The display indicates the frequency tuned to ­ on FM in MHz, and on AM in kHz. The automatic search will stop as soon as it has found a station worthy of reception (of a signal strength sufficient for good reception). It then can be restarted with the ¢ AUTO TUNING button (brief or long pressure). TIME I Frequency Tuning in the FM Band Select the FM band. Manual tuning Tune to the desired station by briefly pressing one of the buttons TUNING or TUNING . If the TUNING or TUNING button is kept pressed, the frequency range will be sanned in 50 kHz steps at high speed until the respective button is released. I 8:0 0 BATT. CHECK TUNING 0. . . 1. . . 2. . . 3. . . 4. . . 5 FM LW MW SW : 8. 9. 8. 6. 0 kHz MHz 0 Frequency Tuning in the AM Bands Select the AM range. Selecting an AM band Press the ¢ AM button repeatedly until the desired AM band is selected. Each pressure on the button steps through the AM band in the order LW MW SW LW MW etc. 0 Automatic tuning (AUTO TUNING) This frequency search is started by pressing the ¢ AUTO TUNING button. Short presssure: Search is started in direction of higher frequencies. The search function operates with 50 kHz steps. 15 Station Tuning Adjusting the tuning steps The tuning steps are adjusted with the ¢ STEP button. With the unit switched on, you can switch between: 1 kHz or 9 kHz on LW 1 kHz or 5 kHz on SW 1 kHz or 9 resp. Repeatedly press the ¢ STEP button until the desired tuning step value (e. g. , in the figure, STEP 9KHZ) is indicated in the display. TIME I This is a precaution to avoid accidental tuning step switching. ON-TIME TIME I 8 6:3 0 FM LW MW SW 8. 8. 8. I. 0 00 kHz MHz When activating the automatic tuning mode, the unit automatically switches to the higher tuning step. Manual tuning ­ Tune to the desired station by briefly pressing on the TUNING or TUNING button. Each pressure on the button performs a tuning step of the value adjusted for the respective waveband (FM: 50 kHz, AM: see chapter "Adjusting the tuning steps"). [. . . ] The programmed wake-up time remains stored in memory. Wake-Up with Sound Signal (Date Reminder) Select "Wake-up with sound signal" (symbol ¢ AUTO button. "Wake-up with signal sound" is possible, if ­ the radio is switched off (wake-up), ­ the radio is switched on (date reminder). The radio is automatically switched off and the sound signal is started. If you press the ¶ SNOOZE button, the alarm sound will be switched off for about 5 minutes and the symbol is flashing in the display. [. . . ]