User manual GRUNDIG SATELLIT 650

[. . . ] Select FM by pressing the FM button, MW(AM) and Longwave by pressing the MW/LW button (press it twice if necessary), Shortwave by pressing the SW button sequentially until you have selected the desired band (the band number flashes in the upper right corner of the display) and the Aircraft band by pressing the AIR button. NOTE: Be sure to fully extend the telescopic antenna when listening to SW, FM and AIR. To learn about shortwave we recommend the two publications below, published yearly and available from major booksellers. Additionally, the Internet is a great resource for learning about shortwave. [. . . ] Use this method when the desired frequency of a radio station is known. Quick, short, sequential presses of the buttons enables tuning up or down frequency. In Auto Tuning the radio scans from one station to the next, stays on the new station for 5 seconds and then moves on. select FAST or SLOW tuning with the STEP button , under the tuning knob. If you want to LOCK the tuning knob press the STEP button for about 3 seconds. Use the BANDWIDTH button to choose wide or narrow selectivity, which is shown in the lower right corner of the display as WIDE or NARROW. Using WIDE usually results in better audio fidelity, while using narrow limits the audio fidelity somewhat. Button when in the FM band to take the radio in or out of stereo reception mode. When it's in stereo mode, STEREO appears under the left side of the frequency in the display, next to FM. As long as you are not using headphones or earphones, it can be left in mono mode. There are two separate sets of 500 memories, allowing for great flexibility of memory storage. The SATELLIT 650's clock is in 24-hour format and can be set with the radio on or off. When the radio is turned on the clock shows in the upper right corner of the display. Press the TIME button for about a second or until you see the hour flashing. While it's flashing turn the TUNING knob to set it to the correct hour, then press TIME and note that the minutes are flashing. While it's flashing turn the TUNING knob to set it to the correct minutes, then press TIME. Note that after setting the hour or minutes you can simply let the flashing number time-out, without pressing the TIME button. The SATELLIT 650 has two, independently programmable alarm timers to turn it on and off at a specified time. 2 button for a second or until you see the alarm hour flashing in the upper right corner of the display. While it's flashing adjust the hour with the TUNING knob and press the AL. While it's flashing adjust the alarm minutes with the TUNING knob and press the AL. While it's flashing adjust the time that the radio is to play with the TUNING knob and press the AL. [. . . ] If you do this indoors, position the wire as close to windows as possible. Plug a 10 to 20 meter or 30 to 60 foot wire into the black socket and let it run on the floor or ground. Or attach the black socket to a cold water pipe with as short a piece of wire as possible. on the rotateable AM antenna , at the top of the radio , is a socket for 50 or 75 Ohm plug-in AM antennas. [. . . ]