User manual GRUNDIG RR 300 CD

[. . . ] CAUTION: Using any equipment or devices other than those described and specified in these operating instructions, or tampering with the unit in any way, can result in dangerous exposure to radiation. The lens may cloud over if the CD player is moved from cold to warm surroundings. Caution should be exercised if the set is placed on furniture as surfaces are often coated with lacquers and plastic finishes containing additives which attack the material of which the feet of the set are made, leaving stains which can only be removed with difficulty or not at all. To ensure a good recording and playback quality, clean the indicated parts ABC after every 50 hours of operation or, on average, once a month. [. . . ] Always hold the CD at the edge and always store it in its box after use with the label facing up. To remove dust and dirt, breathe on the CD and wipe it with a soft, lint-free cloth in a straight line from the center towards the edge. ­ 'PAUSE' lights up and the track number indication starts flashing. ­ The CD player also goes to position STOP: ­ when the end of the CD is reached; ­ if you move the Function selector; ­ if the batteries run down or if the power supply is interrupted. ­ If you select CD and have not inserted a CD, `--` appears on the display. Selecting another track during play · Press R-SKIP S or F-SKIP T until the required track number appears in the display. Starting with a particular track · Press R-SKIP S or F-SKIP T until the required track number appears in the display. note: This function can be described as "audibly" searching for a title. During the search, volume is reduced and returns to its adjusted level as soon as the button is released. ­ The track will now be repeated continuously ­ The display shows: 'REPEAT ONE' Repeating the CD · Press REPEAT again to repeat all tracks on the CD. The CD will now be repeated continuously ­ The display shows: 'REPEAT ALL' · To switch the repeat mode off, press REPEAT one more time. The tracks are played in random order until all of them have been played once. By pressing RANDOM during playback, random play starts from the end of the playing track. The function is deactivated by pressing STOP 9 and opening the CD door (in which case the CD stops) or RANDOM; in this case the remaining tracks are played in their normal order. By programming the player you can play up to 20 tracks in any desired order. If you exceed the maximum of 20 tracks, the programme function will start again from the first track. The function is deactivated by pressing STOP 9 (in which case the CD stops) or INTRO; in this case the remaining tracks are played back in the normal way. ­ The track number blinks on the display and 'MEMORY' lights up. 'MEMORY' starts blinking again and the display will show '02'. ­ The display shows the first memory location and then the programmed track number. The display shows the second memory location and then its programmed track number. ­ Copyright: Recording is permissible insofar copyright or other rights of third parties are not infringed. [. . . ] As soon as the desired passage is reached, pause the CD and then start recording by pressing 0. If a fault occurs, first check the points listed below before taking the set for repair. If you are unable to remedy a problem by following these hints, consult your dealer or service centre. WARNING: Under no circumstances should you try to repair the set yourself, as this would invalidate the guarantee. [. . . ]