User manual GRUNDIG PSW 5000

[. . . ] No warranty claims are accepted for damage caused by incorrect handling. Even if the device is switched off, it can be damaged by a lightning strike to the mains. Please note when deciding where to put the device that furniture surfaces are covered by various types of lacquer and plastic, most of which contain chemical additives. These may cause corrosion to the feet of the device, thus resulting in stains on the surface of the furniture which can be difficult or impossible to remove. Environmental note This product has been made from high-quality parts and materials which can be re-used and recycled. [. . . ] Environmental note: Batteries, including those which contain no heavy metal, should not be disposed of with household waste. Please dispose of used batteries in an environmentally responsible manner. Find out about the legal regulations which apply in your area. Mains operation 1 2 Insert the cable of the mains adapter in the »DC 9 V (bottom of the device). Caution: The only way to disconnect the device from the mains supply is to unplug the mains adapter. ENGLISH Ó « socket of the loudspeaker 15 OPERATION ____________________________________________________ General information The PSW 5000 system works with a wireless audio receiver integrated in the outdoor loudspeaker, which enables the reception of the wireless audio signals from the wireless module. The wireless audio transmission range is limited by national and international regulations to prevent radio interference from neighbouring devices. This range is restricted inside buildings, depending on the construction materials used. Avoid placing the system near metal objects or electrical devices such as cordless telephones which use radio signals. Since the audio signals are not transmitted on an exclusive range we cannot guarantee that this will not cause interference. In some circumstances, people, walls and other surfaces can reflect radio signals. Reflected signals can mix with non-reflected signals, thus causing a type of interference known as multipath reception. If such interference does occur, simply position the transmitter or the loudspeaker differently. Switching on the system 1 Switch on the hi-fi system. Note: If the audio outputs of your hi-fi system have an adjustable output level, you can adjust the volume on the hi-fi system. If the audio output levels are fixed, you have to adjust the volume on the loudspeaker. 2 Set the transmission channel (1, 2 or 3) with »Channel 3 2 1 Off« on the wireless module. ­ The operating display of the wireless module (front of the device) lights up. On the loudspeaker, set the same transmission channel (1, 2 or 3) as set on the wireless module using »Channel 1 2 3« (bottom of the device). If necessary, set the required volume on the loudspeaker with »­ z +«. Note: If signal interference occurs during operation, select another transmission channel which corresponds on both the wireless module and the loudspeaker. 3 4 5 16 OPERATION ____________________________________________________ Connecting external audio sources You can relay the sound of an external audio source (e. g. Plug the audio cable in the corresponding output socket of the external audio source. [. . . ] These products fulfil the European directives 89/336/EEC, 73/23/EEC and 93/68/EEC. These devices conform to the safety regulation DIN EN 60065 (VDE 0860) and therefore the international safety regulation IEC 60065. No warranty claims are accepted for damage caused by incorrect handling. The type plate is located on the bottom of the devices. Wireless module Power supply Mains adapter DC 9 V, 150 mA, 50/60 Hz Outdoor loudspeaker Power supply Mains operation: Mains adapter DC 9 V, 2000 mA, 50/60 Hz Batteries: 8 x 1. 5 V, LR 20/AM 1/D-Size RF transmission frequency 863 - 865 Mhz Dimensions and weight W x H x D: Weight: 40 x 137 x 121 mm approx. [. . . ]