User manual GRUNDIG MS 4020

[. . . ] Children should always be supervised to ensure that they do not play with the appliance. No warranty claims are accepted for damage caused by improper handling. Do not operate the appliance unless you use it for shaving. The appliance is designed for domestic use only. [. . . ] 5 Switch off the appliance with the On/Off switch B and disconnect the plug from the wall socket. Replace any damaged parts before shaving. 2 Plug the power adapter K into the power adapter socket C and the power adapter plug into the wall socket. 4 Shave with slow, gentle movements against the direction of beard growth. Caution Always pull the skin taut when shaving difficult areas such as your lower jaw. In the case of thick or copious beard growth which cannot be removed by just one shave, do one quick shave and then a more thorough second one. Do not press too hard as you may damage the foils. 5 After use, switch off the appliance with the On/Off switch B , disconnect the plug from the wall socket and put the plastic cap back on. 1 6 ENGLISH INFORMATION ____________________ _ Cleaning and care General information The appliance must be cleaned regularly so that you can continue to enjoy its top performance and optimum results. 4 To remove all hair, hold the blade blocks F under running water and switch on the appliance. Cleaning with water 1 Push the On/Off switch B to switch off the appliance. 2 To remove the foil frame, push one of the side lock buttons E with your thumb to lift up this side of the foil frame. Then push the second button at the other side and lift up the foil frame. Gently shake out the remaining moisture and then dry off the appliance with a clean cloth. 6 Replace the foil frame A and let it latch into place. Cleaning with the brush 1 Push the On/Off switch B to switch off the appliance. To do so, push the side lock buttons E . 1 ENGLISH 7 INFORMATION ____________________ _ 3 Remove the blade blocks F for cleaning by pulling them upwards off the oscillator H . 4 Carefully brush hair clippings out of the blade blocks, the foils and the housing. Caution To ensure smooth operation, the foil frame must be properly seated in the housing. Never take the foils out of the frame. Replacing the foil frames 1 Remove the foil frame A . Caution Ensure that the foil frame is firmly in position and cannot move within the housing. Replacing the blade blocks 1 Remove the blade blocks F by pulling them upwards off the oscillator H . Caution Replacing the foil frames and blade blocks You can replace the foil frame and blade blocks. [. . . ] Therefore, do not dispose of the device and the built-in rechargeable battery along with normal household waste at the end of its service life. Take it to a collection point for the recycling of electrical and electronic equipment where the battery is taken out of the device and disposed separately. This is indicated by this symbol on the product, in the operating manual and on the packaging. [. . . ]