User manual GRUNDIG MASQ RRCD 9100 PLL

[. . . ] RADIO CASSETTE RECORDER WITH CD MASQ RRCD 9100 PLL ENGLISH CARE AND SAFETY ______________________________ To ensure that this device provides you with long-term satisfaction and enjoyment, please observe the following instructions. This device is designed for the recording and playback of audio signals. Any other use is expressly prohibited. °C °C 2h RADIO CASSETTE RECORDER WITH CD RR 6000 CD OPEN/CLOSE Protect the device, the CDs and cassettes from rain, moisture (dripping or splashing water), sand and heat. Do not insert any foreign bodies in the CD or tape compartment of the device. RADIO CASSETTE RECORDER WITH CD RR 6000 CD OPEN/CLOSE VICE ! [. . . ] ­ If the device is set to stereo reception and is receiving a mono signal, the » « display flashes. MHz 2 Automatic station search (ASP) By starting the automatic station search, you can delete all the existing preset stations and at the same time allocate new radio stations to them. 1 Start the automatic search in tuner mode by pressing and holding down »PROGRAM/PROG. «. ­ After the search has finished, the station stored in position 01 can be heard. Note: The automatic station search can be interrupted with »PROGRAM/ PROG. «. 33 ENGLISH CD MODE _________________________________________ The device is suitable for CD-DAs, CD-Rs and CD-RWs. If the device is unable to scan CDs perfectly, use a standard commercially available cleaning CD to clean the laser optics. Always keep the CD compartment closed to prevent dust from collecting on the laser optics. Keep the surfaces of CDs clean. Selecting the CD input source FLAT no d ISC CD 1 Select CD as the input source with » CD II«. ­ If there is no CD in the compartment, the »TR 00 00:00« appears briefly, and then »no d ISC«. ­ Display: »OPEn « flashes, then »OPEn « . Insert a CD in the compartment with its label facing upwards. message FLAT 2 OPEn CD 3 4 FLAT TR CD 12 58:14 Close the lid of the CD compartment with » « on the device. »58:14«, appear in the display. CD playback 1 FLAT TR CD 01 01:22 2 Press »CD II« to start playback. ­ Display: » «, the current track number and the elapsed playing time of the track. To resume playback, press » To stop playback, press »7 «. II«. FLAT TR CD II 01 01:36 3 4 Repeating the current track 1 Press »5a« briefly during playback. ­ The track is repeated from the beginning. Selecting a different track 1 During playback, keep pressing »5a« or »s « until the number of 6 the track you want to hear appears in the display. ­ Playback of the selected track starts automatically. 34 CD MODE _____________________________________________ Searching for a passage within a track 1 During playback, press »5a« or »s « and hold it down until you 6 find the passage you want to hear. ­ When »5a« or »s « are released, playback begins. 6 Note: During the search the volume is reduced. Calling up the REPEAT functions REPEAT 1 TR CD POP The repeat functions enable you to repeat a single track or the whole CD. ­ »REPEAT 1« appears in the display and the current track is continuously repeated. ­ »REPEAT ALL« appears in the display and the CD is continuously repeated. To quit the functions, press »REPEAT« again. 06 02:14 POP REPEAT ALL TR CD 2 03 01:45 3 Playing the introductions of tracks on the CD FLAT TR CD INTRO 1 03 00:05 2 Press »INTRO« when the CD is in the STOP position. ­ Playback starts automatically, and the first ten seconds of each track are played. [. . . ] 8 x 1. 5 Volt (R20, UM1, D) Tape unit Recording medium:. . . . . . . . Compact cassette according to DIN 45516 Track position: International quarter-track Tape speed: . . . . . . . . . . . . . . . . . . . . . . 0. 25 % Output: DIN 45324, 10% THD Music signal power: . . . . . . . . . . . . . . . . . 2 x 5 W Stereo headphone jack 3, 5 mm ø Radio unit Frequency bands FM 87. 5 . . . 108. 0 MHz MW 522 . . . 502 x 215 x 313 mm Weight . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 6. 1 kg CD unit Technical and optical modifications reserved 41 ENGLISH Frequency response: . . . . [. . . ]