User manual GRUNDIG GV 600 SV

[. . . ] VIDEORECORDER GV 600 SV Inserting batteries into the remote control . 6-7 Programming with the user guide and manual data entry, variant 2 . 25 The User Guide Settings 8 9-15 Copying from a second recorder, CD-i player Operation with a Satellite Receiver Operation with a PAY-TV Decoder Special Functions 26 27-30 31 32-35 Tuning the TV set to the recorder 9 Tuning . 9 Tuning TV stations 10-14 Transfer of data from the TV set (Megalogic function) . [. . . ] The TV set can be switched off during recording or another programme position can be selected. Immediate recording can also be done with television sets without Megalogic functions. Recorder and television set must be connected with a Euro AV cable. 6 7 Remove the cassette by pressing the N/w button. Switch off the recorder using the A/ z button. Recording I 19 Entering a stop time ! Recording continues to the end of the tape. The recorder switches automatically to rewind, rewinds the tape to the beginning and switches to standby. For this, there are two options: Entering to the exact minute; Entering in 30-minute steps. Use the buttons on the remote control for this function. Assembling recordings with clean joints (assembly editing) 1 During playback, locate the tape position at which you wish to join the recording. Enter the desired programme as a one- or two-digit number using the numbered buttons 1 . . . ­ During playback you will see seamless transitions without flaws. This is called assembly editing. 2 3 4 Recording 20 1 2 Entering stop time to the exact minute Press the K button during recording. Enter the desired stop time as a four-digit number using the numbered buttons 1 . . . 0 and confirm using the G button. 1 2 Entering stop time in 30-minute steps Press the K button during recording. During recording, enter the desired stop time by pressing the K button repeatedly (max. 20 times = 600 minutes). 1 Changing the stop time If the stop time is to be changed during recording, press the K button, enter the new stop time using the numbered buttons 1 . . . 0 and confirm using the G button. The options for TIMER programming You can programme: ­ Six broadcasts over a period of 31 days. ­ With or without VPS/PDC control. If you wish to record a number of TV programmes on one day, you must decide which one is to be recorded completely if there is a risk of alterations to timing. Example: You wish to record the 1st station from 20:15 to 21:45 Hrs and the 2nd station from 21:50 to 22:30 hrs. However, the programme from the 1st station is extended by 15 minutes. The recorder records this programme until 22:00, controlled by the VPS/PDC signal. If the programme from the 2nd station is to be recorded from the beginning you must delete VPS/PDC control when programming the 1st station. The length of the recording is then controlled by the switch-on and switch-off times. The recording of the 2nd station starts at 21:50. You can choose from two variants: 1. With the user guide and manual data entry. VPS/PDC ­ the Video Programme System VPS/PDC control when programming recording guarantees that your desired broadcasts are always recorded completely. [. . . ] If you have forgotten the code number you can de-activate the lock as follows: Remove mains plug then press any button on the recorder and hold it down. Please note this also erases all settings, including the programme positions. Recording of TV stations not possible (only snow to be seen on screen). Aerial cable not connected. Failure of the TV transmitter or aerial system is defective. Connect aerial cable. Tune to station. Check by selecting the station to be recorded on the TV set or ask your neighbour if he can receive this station. [. . . ]