User manual GRUNDIG CDP 440

[. . . ] · You can clean the CD player cabinet with a soft and slightly dampened chamois leather. · The lens may cloud over when the set is suddenly moved from cold to warm surroundings. Leave the CD player in a warm environment until the moisture evaporates. · To remove dust and dirt from the CD, breathe on the CD and wipe it with a soft, lint-free cloth in a straight line from the center towards the edge. [. . . ] · Install the rechargeable batteries in the battery compartment as described before. · Connect the AC adapter to the CD-player and then to the wall outlet. · The batteries should be allowed to recharge for 8 hours for full capacity. · The ambient temperature for recharging should be between 5°C and 40°C. · The player can be operated while the batteries are being recharged. GB The display indicates when the battery voltage is too low: · When the indicator flashes, the batteries are getting too weak. · When appears continuously, the battery voltage is too low and the CD player will soon shut down. Note: The battery supply is switched off when the DC IN 6. 0 V socket is in use. When changing over to battery supply, pull out the plug from the DC IN 6. 0 V socket. DAS TRACK MIN SEC Mains adapter (supplied) 1 Make sure that the local voltage corresponds to the voltage of the adapter. 2 Connect the supplied mains adapter (6. 0 V/450 mA Direct Current plus-pole to the centre pin) to the player's DC IN 6. 0 V jack and to the wall outlet. Note: The CD-player remains connected to the mains even when it is switched off. The unit is only fully isolated from the mains if the mains adapter is removed from the wall socket. 12 Note on Environmental Protection Do not throw exhausted batteries in the household refuse. Hand over the old batteries to your dealer or public collecting points when buying new ones. Line out DC IN -<+ 6. 0 V T OU E LIN E LIN T OU (AUX, LINE IN) CD IN LINE OUT Reproduction through a stereo system · Turn down the volume of your stereo system. · Connect a signal lead to the LINE OUT jack of the CD player and to the input jacks CD IN, AUX(iliary) or LINE IN of the other set (amplifier, receiver, radio cassette recorder etc. ). · Adjust the sound with the controls of the stereo system. CDP 410/440 page 13 CD PLAYER Inserting a CD · · · · Open the lid by sliding the OPEN button and lifting the lid gently. In addition to standard 12 cm CD's, you can also play 8 cm CD singles without an adapter. The total playing time and the total number of tracks appear on the display. Removing the CD: · Open the CD door only if the CD player is in position STOP. · To take out the CD, open the CD lid by sliding the OPEN switch and lifting the lid gently. · Hold the CD by its edge and press the hub gently. Automatic Power-Off This CD-player is equipped with an automatic power-off function. · In STOP mode, the player automatically shuts down approximately 30 seconds after the last operation. · If you press STOP while the set is in STOP mode, the player also shuts down. [. . . ] · ­ ­ ­ 1 GB 1 ALL 2 INT 3 4 5 DAS TRACK MIN SEC Checking the programme · Press the PROG button repeatedly until P flashes on the display. ­ Each press of the PROG button will now show each stored number in the order entered. · You can now add tracks to the sequence as described above (up to 20). Programming By programming the player you can play up to 20 tracks in any desired order. If you exceed the maximum of 20 tracks, the programme function will start again from the beginning. [. . . ]