User manual GRUNDIG CDP 180

[. . . ] Leave the CD player in a warm environment until the moisture evaporates. You can clean the CD player with a soft and slightly dampened chamois leather. Always pick up the CD by the edge and put it back in its box after use. [. . . ] When changing over to battery supply, pull out the plug from the DC IN 6. New batteries or those not used for some time should first be charged completely. In STOP mode, the player automatically shuts down approximately 30 seconds after the last operation. If you press STOP 9 while the set is in STOP mode, the player also shuts down. ­ The CD player will also switch itself off: ­ when the battery capacity is exhausted or in other cases of interrupted power supply. note: The CD-player remains connected to the mains even when it is switched off. The unit is only fully isolated from the mains if the mains adapter is removed from the wall socket. Note: Furniture surfaces are covered with a wide variety of synthetic materials and varnishes containing chemical additives. These can react with the materials used for the base of the CD player, leaving marks on the surface which can be difficult or impossible to remove. In addition to standard 12 cm CD's, you can also play 8 cm CD singles without an adapter. ­ After that, the display shows the current track number and its elapsed playing time. ­ The position of these controls does not affect the output signal of the LINE OUT socket. ­ If no button is pressed for 30 seconds, the set will switch off automatically. Selecting another track during playback · press SKIP· SEARCH S or T until the required track number appears in the display. SEARCH S or T button during playback to find a particular passage in backward or forward direction. The MODE button enables you to choose among five different play modes. Press the MODE button repeatedly until the desired play format appears on the display indicator. 3 INTRO: plays the first 10 seconds of each title on the CD; the CD player stops play after the last title. [. . . ] This unit complies with the safety regulations according to VDE 0860 / BS 415 and thus with the international safety regulation according to IEC 65. If a fault occurs, first check the points listed below before taking the set for repair. If you are unable to remedy a problem by following these hints, consult your dealer or service centre. [. . . ]