User manual GRAEF ES 400

[. . . ] Do not leave the unit unattended during operation and decalcification. Observe the notes on the requirements regarding the installation DE Location and the electrical connection of the unit in order to avoid Do not place the unit in the dishwasher or under running water. The surfaces heat up during use and remain hot for a while This appliance is intended for domestic and similar use, such as: In staff kitchens for shops and offices Another or any exceeding use shall not be considered intended. Please therefore do the following: · Observe the procedures described in these operating instructions. [. . . ] Do not place the appliance on hot surfaces, such as hotplates, or near them. The unit is not designed for installation in a wall cabinet or a built-in cupboard. The socket has to be easily accessible so that the power cable can be removed For safe and fault-free operation of the unit, the following requirements have to be met during the electrical connection: · Before connecting the unit, compare the connecting data (voltage and frequency) On the type plate with those of your energy network. Make sure that the power cable is not damaged and is not laid across hot surfaces or sharp edges. The electric safety of the unit is ensured only when it is connected to a socket with protective conductor installed correctly. Operation at a socket outlet without a protective earth conductor is not permitted. If in doubt, let the house installation checked by a trained electrician. The manufacturer shall not assume responsibility for damage which has been caused by absent or interrupted protective 22 conductor. Before first use, clean the strainer support (not the unit) and the water tank under Running water to remove any production residue. to switch the Unit on again, turn the rotary knob briefly to the left and back again to the centre NL Observe the following safety instructions to prevent hazards and material dam- DK During use, the surfaces become hot!While water is running through the machine, never remove the group handle Filled with coffee grounds, because it is under pressure. Before preparing the espresso, check that the strainer support is firmly tight- To avoid potential hazards, use the unit only for coffee preparation and frothing Any other use is not permitted. Make sure that the recess on the strainer insert is on the recess in the strainer support. The strainer insert now sits loosely in the strainer support, but does not fall out. The following steps are used to warm up the strainer support, the strainer insert and the cups. If the control lamp lights up permanently, the unit is ready for operation. Place the strainer support without coffee powder under the brewing head. Hold the unit firmly and turn the handle of the strainer support to the right. Let the cup run half full, to bring the system to desired temperature. The distance between the upper edge and the coffee grounds should be ap- Wipe off excessive coffee grounds from the edge and clamp in the strainer Place one or two cups underneath the outlet. Turn the rotary knob back to centre position when the requested amount of Hold the strainer insert in place with the help of the strainer holder and tap the Coffee grounds into a pomace tray (not included). mILK FROTHING WITH PANNARELLO If the unit is switched off, switch it back on again. [. . . ] TWO-YEAR WARRANTY For this product, we assume 24 months manufacturer warranty for defects, which are due to production or material defects. Of the German Civil Code (BGB) shall remain unaffected by this regulation. The warranty does not cover damage caused by improper handling or use as well as defects which only slightly influence the function or the value of the appliance. Furthermore, we do not assume any liability for damages due to a lack of or insufficient descaling and care. [. . . ]