User manual GP BATTERIES SS103A

[. . . ] Recharge your SecureStartTM immediately when the Orange or Red light is on. Recharging of SecureStartTM is required monthly and is more frequently during summer when temperature exceeds 29°C (85°F). It is recommended to store your SecureStartTM in a cool, dry location to maximize its performance. Failure to follow the charging instructions may shorten your unit's service life. Warranty Terms and Conditions Your SecureStart is covered by a conditional, limited warranty to the original purchaser. [. . . ] Connect the Red positive (+) cable clamp first to the vehicle battery's positive (+) terminal. Rotate clamp slightly to ensure a good connection. NOTE: Use SecureStartTM only on 3-litre or smaller gasoline-powered engines if without car battery. 4. Connect the Black negative (-) cable clamp last to vehicle chassis, engine block, hanging hook or other unpainted, non-moving metal surface that is away from the vehicle battery. Rotate clamp slightly to ensure a good connection. 3 4 IMPORTANT Read All Instructions And Safety Warnings Before Using SecureStartTM Warning / Safety Information 1. Read and follow all instructions in this manual before using the SecureStartTM. Follow all instructions published by the automobile and car battery manufacturers, especially the procedure of jump-starting of a car. NEVER ALLOW cable clamps ("+" & "-") to TOUCH each other. Cable clamps are "live" at all times, and will spark once they touch, SecureStartTM will generate heat too. Always ensure clamps are stowed securely in clamp holders when not connected for jump-starting. ALWAYS VERIFY car battery positive terminal (RED "+") before connecting cable clamps to battery. Handle SecureStartTM and car battery with care while jump-starting a car. Car batteries generate hydrogen gas during normal battery operation, such gas may cause explosion with a spark. Care should be taken to ensure sparks are not generated near the car battery. Keep hands and cables clear of fan blades, belts pulleys and other moving parts when working near a running engine. Remove jewelry, watch and loose clothing when near the engine compartment. Do not charge the SecureStartTM in wet or moist locations through the DC charging jack. Do not charge the SecureStartTM in an airtight container, provide adequate ventilation during charging. STEP 3: Replace 13 pieces of AA alkaline batteries. - locate battery cover on back of the SecureStart and push cover slightly in direction of arrow. - remove 13 pieces of AA batteries and replace with the fresh AA Ultra Alkaline batteries. Orientate batteries according to directions indicated in bottom of battery compartment. - slide battery cover over battery compartment until cover locks in place. STEP 4: Charge your SecureStartTM by using car adaptor or wall adaptor (not provided) immediately. By Car Adaptor - 6 hours accumulatively or permanently plugged-in: Plug the car adaptor into the cigarette lighter socket of your vehicle. [. . . ] 2 5 Getting to Know Your SecureStartTM Fuel-Gaugein Indicator DC Charging Jack Fuel-Gauge Switch AA Ultra Alkaline Battery Compartment 13 pieces of AA Ultra Alkaline Batteries WARRANTY CARD Product Type Serial No. SecureStart SS103A FRONT REAR Date of Purchase Customer's Contact Warranty Period: 1 year from date of purchase Name: Address: Tel No. : 13 cells AA ultra Alkaline Battery Pack with connector wire 12V DC Car Adaptor Green LED OR Black Negative (-) Cable Clamp Red Negative (+) Cable Clamp 15VDC minimum 1Amp Wall Adaptor (Not provided) Retailer WARNING: DO NOT allow the cable clamps to TOUCH each other!If they touch each other, severe sparks may cause personal injury and battery explosion. Use only the car adaptor or wall adaptor supplied with your SecureStartTM for charging. [. . . ]