User manual GP BATTERIES PB540

[. . . ] For brand new batteries, 2 to 3 cycles of charging and usage are required to optimize the batteries' performance. If batteries have been stored for more than one week, always recharge them before use. It is normal for batteries to become warm during charging and they will gradually cool down to room temperature after being fully charged. Remove batteries from an electrical device if it will not be used for a long time. [. . . ] Insert AA or AAA NiMH batteries into the charging slots according to the polarity indications (+/-). When inserting batteries into the charging slot, slide down the negative contact to ensure the battery is placed properly. Pull out the folded plug pins of the charger until they reach the correct position. Connect the charger directly into a corresponding AC power outlet (Fig 2). The red LED indicator will flash and the charger will stop charging if alkaline, rechargeable alkaline or damaged batteries are mistakenly inserted into the charging slots. Once charging is complete, unplug the charger from power source and remove the batteries. To remove the travel plug, push the button with a pen to release the travel plug. NOTE: Make sure the travel plug is firmly attached with For best performance and optimal safety, charge GP NiMH batteries with GP PowerBank. For brand new batteries, 2 to 3 cycles of charging and usage are required to optimize the batteries' performance. If batteries have been stored for more than one week, always recharge them before use. It is normal for batteries to become warm during charging and they will gradually cool down to room temperature after being fully charged. Remove batteries from an electrical device if it will not be used for a long time. The travel plug could only be detached when the appliance is disconnected from the socket outlet. In order to avoid electrical shock, do not connect the travel plug to the socket outlet when it is detached. 4V DC Nabíjecí proud (mA) AA/AAA 600 nabíjecí proud (mA) AA/AAA 100 Compact and lightweight AC100-240V for worldwide use Additional travel plugs for travelling Charge 1 to 4 pieces of AA or AAA rechargeable batteries Equipped with 4 individual charging channels Charge NiMH rechargeable batteries only Termination methods - Individual minus delta voltage (-dV) - Individual temperature sensor - Safety timer - Primary and damaged batteries detection - One dual colour LED indicator Do not charge other types of batteries, such as alkaline, carbon zinc, lithium, rechargeable alkaline or any other unspecified batteries, as they may leak or burst, causing personal injury and damage. Never use an extension cord or any attachment not recommended by GP, as this may lead to a risk of fire, electric shock or personal injury. Unplug the charger from the outlet before attempting to clean or when not in use. This appliance is not intended for use by persons (including children) with reduced physical, sensory or mental capabilities, or lack of experience and knowledge, unless they have been given supervision or instruction concerning use of the applinance by a person responsible for their safety. [. . . ] The red LED indicator will flash and the charger will stop charging if alkaline, rechargeable alkaline or damaged batteries are mistakenly inserted into the charging slots. Once charging is complete, unplug the charger from power W-540 source and remove the batteries. Do not dispose of electrical appliances as unsorted municipal waste, use separate collection facilities. Contact your local government for information regarding the collection systems available. [. . . ]