User manual GOLDEN STATE INTERNATIONAL 40-904

[. . . ]  The appliance must be installed by a qualified professional in accordance with the instructions provided.  Any necessary adjustment or maintenance must be performed after the cooker has been disconnected from the electricity supply. The legs* fit into the slots on the underside of the base of the cooker. GB Positioning and levelling  It is possible to install the appliance alongside cupboards whose height does not exceed that of the hob surface. [. . . ] - button: the power of the cooking zone Programming the cooking duration !All the cooking zones may be programmed simultaneously, for a duration between 1 and 99 minutes. Period of time, the display scrolls quickly though the power levels and timer minutes. - + or button is pressed for an extended Switching on the hob To switch the hob on, press and hold the for approximately one second. The indicator Switching on the cooking zones Each cooking zone is controlled using a selector button and a power adjustment device light corresponding to the selected zone will start flashing. Confirm by pressing the button or automatic selection occurs after 10 seconds. A buzzer sounds for approximately 1 minute and the cooking zone switches off when the set programme has finished. Using multiple programmes and the display If one or more hotplates are programmed, the display will show the data for the hotplate with the least time remaining, and the light corresponding to the position of the hotplate will flash. The lights corresponding to the other hotplates programmed will be switched on. To visualise the time remaining for the other programmed hotplates, press the button repeatedly: the time remaining for each hotplate will be shown sequentially in clockwise order, starting from the front left hotplate. - + and consisting of a double • To begin operating a cooking zone, press the corresponding control button and set the desired power level (between 0 and 9) using the buttons - + and button. To activate the “demo” mode the hob must be switched on, with all the hotplates switched off. • Make sure that the base of the cookware is always clean and dry, in order to fully utilise and extend the life of both the cooking zones and the cookware. 30 • Avoid using the same cookware which has been used on gas burners: the heat concentration on gas burners may distort the base of the pan, causing it not to adhere correctly. Power level 1 2 3 4 Maximum operating time in hours 9 8 7 6 5 4 3 2 1 GB Safety devices Pan sensor Each cooking zone is equipped with a pan sensor device. The hotplate only emits heat when a pan with suitable measurements for the cooking zone is placed on it. If the indicator light is flashing, it may indicate: • An incompatible pan • A pan whose diameter is too small • The pan has been removed from the hotplate. Residual heat indicators Each cooking zone is equipped with a residual heat indicator. This indicator signals which cooking zones are still at a high temperature. It is possible, for example, to keep a dish warm or melt butter or chocolate. The display switches off power display will show when the cooking zone has cooled sufficiently. Overheating protection If the electronic elements overheat, the hob switches off automatically and followed by a flashing number. [. . . ] Unscrew the light bulb and replace it with a similar one: Wattage 15 W, cap E 14. Replace the glass cover, making sure the seal is positioned correctly (see diagram). 35 GB Automatic cleaning using the FAST CLEAN function With the FAST CLEAN mode, the internal temperature of the oven reaches 500°C. The pyrolytic cycle is activated, burning away food and grime residues. [. . . ]