User manual GMC ENVOY GTK 2004

[. . . ] Please read this information and your Owner Manual to ensure an outstanding ownership experience. Note that your vehicle may not include all the features described in this booklet. Place this booklet in your Owner Manual portfolio for easy reference. Instrument Panel . Rear Window Defogger Instrument Panel Cluster B C D E F A Your vehicle's instrument panel is equipped with this cluster or one very similar to it. [. . . ] · If no station is found, NO TRAF appears on the display. Display a station's INFO message when INFO appears on the display · Press INFO to see the message. Once the complete message has been displayed, INFO disappears from the display. Tune to an RDS broadcast of a selected program type · Turn the P-TYPE knob to select the Program Type you want to listen to. · Press the SEEK or SEEK TYPE button (as applies to your radio). Access one of the two available XM Satellite Radio bands (if equipped) · Press the BAND button until XM1 or XM2 appears on the display. Load one CD into the Six-Disc CD player (if equipped) · With the ignition on, press and release the LOAD side of the LOAD CD button. · Wait for the green indicator light at the right side of the slot to turn green. · Insert the disc partway into the slot, label side up; the player will pull the disc in. 12 Getting to Know Your Envoy Load multiple CDs · With the ignition on, press and hold the LOAD button for two seconds. The unit beeps and the light to the right of the slot begins to flash. · When the light stops flashing and turns green, insert a disc partway, label side up. · The indicator light will begin blinking and turn steadily green. · When loading more than one but fewer than six CDs, press the LOAD button again to signal that loading is complete. · When more than one disc is loaded, a number for each disc is displayed. · To play a specific CD, press the CD AUX button and then the number of the CD you want to hear. · A small bar appears under the CD number that is playing, and the track number appears. See Section 3 of your Owner Manual. Activate the Rainsense feature · Set the wipers to one of five moisture sensitivity settings on the multifunction lever. · The closer the setting is to the OFF position, the less sensitive it will be to moisture. Note: Turn this feature off before entering an automatic car wash. See Section 3 of your Owner Manual. Headlamp Washers (if equipped) A Rainsense Wipers (if equipped) Rainsense Wipers automatically control the frequency of the wipers from OFF to HIGH speed according to the amount of moisture on the windshield. Spray the headlamps with washer fluid · Press the headlamp washer button (see "A" above) located on the instrument panel to the left of the steering wheel. See Section 3 of your Owner Manual. 13 HomeLink ® Universal Transmitter (if equipped) The controls for this feature are located on your overhead console. · Press and hold down the two outside buttons until the indicator light flashes, then release the buttons (about 20 seconds -- do not hold for more than 30 seconds); do not repeat this step for the second or third devices that you plan to add to the HomeLink® system. · Hold the end of your hand-held transmitter up to three inches away from the surface of the universal transmitter and hold its button and the button you wish to assign it to on the HomeLink® system. · Continue holding both buttons (up to 90 seconds may pass as the universal transmitter is being programmed); the indicator light will begin blinking slowly, then more quickly. Programming is complete when the light on the HomeLink® transmitter flashes rapidly. · Release both buttons. · Press and release the HomeLink® button again. · Continue programming additional devices using the transmitters, but do not press the two outside buttons on the HomeLink® transmitter again. If the HomeLink® indicator light blinks rapidly for two seconds and remains on, it indicates that your device (usually a garage door opener) has a "rolling code. " Continue with the following steps: · Press the training button (sometimes marked "LEARN" or "SMART") on the garage door opener motor head unit, making sure that the indicator light flashes to confirm training mode. [. . . ] The last value displayed for each preference is saved automatically. See Section 3 of your Owner Manual. 16 Getting to Know Your Envoy Air Inflator System (if equipped) Locate the air inflator unit and kit · The inflator unit is in the rear compartment on the passenger side of the vehicle, behind an access cover. · An inflator kit, with a 22-foot hose and three nozzle adapters, is located in the glove box. · Attach the appropriate nozzle adapter to the end of the hose (if required). · Press and release the on/off switch to turn the air inflator on. [. . . ]