User manual GIGAFAST EE102-AEX

[. . . ] CardBus 10/100M Ethernet card User Manual Version 1. 2 Regulatory compliance This equipment has been tested and found to comply with the limits for a Class B digital device pursuant to Part 15 of the FCC Rules. This equipment also complies with CE EN55022 Class B and VCCI V3 Class B specifications. These limits are designed to provide reasonable protection against harmful interference when the equipment is operated in a commercial environment. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instruction manual, may cause harmful interference to radio communications. [. . . ] After Windows 95 detects the card, the Update Device Driver Wizard window appears: 12 Win 95/98/2000/ME/NT 3. Windows searches for the driver and the following screen appears: 4. Click Finish to continue, Windows 95 copies driver files to the hard disk. 13 CardBus Ethernet card user manual 5. Click Yes to complete the installation. Driver installation for Windows 98 Follow the steps below to install the CardBus Ethernet card drivers for Windows 98. Insert the CardBus Ethernet card into an available CardBus slot on your notebook 2. After Windows 98 detects the CardBus Ethernet card, the Add New Hardware Wizard window appears: 3. A screen appears prompting you to select an installation method: 14 Win 95/98/2000/ME/NT 4. The following screen appears: 15 CardBus Ethernet card user manual 7. Windows 98 copies files to your hard disk drive, and you see the following screen: 8. Click Finish. Note! Windows 98 may need to copy required system files and will prompt you 16 Win 95/98/2000/ME/NT to input the path to the files. Click Finish. Note! Windows ME may need to copy required system files and will prompt you to input the path to the files. Follow the instructions on your screen, then click OK to continue. You should reboot your system to finish the installation. 23 CardBus Ethernet card user manual Driver installation for Windows NT 4. 0 This installation procedure assumes that you have installed the network component on your computer. To check whether the network component has been installed, double click the Network icon in the Control Panel. If it has not been installed, refer to the Windows NT 4. 0 installation guide for instructions on installing the component. Insert the CardBus Ethernet card into an available CardBus slot on your notebook 2. Double click the Network icon in the Control Panel, and select the Adapters tab as shown in the following screen: 24 Win 95/98/2000/ME/NT 4. Type ¡A:\WinNT40¡¨ w here A Insert the driver disk, and click OK. After finding the installation file, the Select OEM Option window is displayed. 25 CardBus Ethernet card user manual 7. A screens appears prompting you to input the IRQ, I/O port address, and connection type: 8. Select the desired resources and connection type. Note! You must select resources that are not being used by another device; otherwise, you will have a system conflict error. In case of a system conflict error, try another setting and continue. 9. You are returned to the Network window. 26 Win 95/98/2000/ME/NT 10. [. . . ] Click Save, then press <F3> to exit. Artisoft LANtastic version 6. 0 Follow these instructions to install the Artisoft LANtastic Version 6. 0 client for your Ethernet Card: 1. Select Artisoft LANtastic, and specify C:\LANTASTI as the destination directory. When the Select network adapter screen appears, choose NDIS Support for Network Adapters. When the install program prompts you for the manufacturer's driver disk in the Enter NDIS driver directory screen, insert the driver disk. [. . . ]