User manual GIGABYTE GA-H61M-S2V-B3

[. . . ] €¢â€¢ Before installing the devices, make sure they are compliant with the connectors on your computer. €¢â€¢ Before installing the devices, be sure to turn off the devices and your computer. [. . . ] Align the CPU pin one (small triangle marking) with the triangle marking on the CPU socket and gently insert the CPU into the socket. B-2 Once the CPU is positioned into its socket, place one finger down on the middle of the CPU, lowering the socket lever and latching it into the fully locked position. CPU Socket Lever CPU Socket Pin 1 •• Do not force the CPU into the CPU socket. To protect the CPU socket, always replace the protective socket cover when the CPU is not installed. Installing the CPU Cooler C-1 Before installing the CPU cooler, please first add a thin layer of heat sink paste on the surface of the CPU. Then install the cooler (refer to the installation manual for your CPU cooler). C-2 Connect the CPU cooler cable to the CPU_FAN connector located on the motherboard so that the cooler can properly function to prevent the CPU from overheating. 2 Step Installing Memory Note the orientation of the memory module. As indicated in the picture on the left, place your fingers on the top edge of the memory, push down on the memory and insert it vertically into the memory socket. The clips at both ends of the socket will snap into place when the memory module is securely inserted. 3 Step Preparing the Case and Installing a Power Supply Using the GIGABYTE desktop system as the demonstration example, please first remove both sides and the lid of the case in order to install the power supply. Place the power supply in the correct place in the case and secure it with screws. Installation and placement of the power supply may differ depending on the type of case used. To ensure sufficient power can be supplied to your system, it is recommended that a power supply of good quality be used. [. . . ] Pin Assignments A: +MSG- +PW2 1 7 Step Connecting Cables to Internal Connectors Pin Assignments B: +MSG- +PW+SPEAK20 19 +SPEAK- Front Panel Header +HD- -RES+ NC +HD- -RES+ -CI+ +PWR- MSG: Message/Power/Sleep LED PWR: Power LED PW: Power Switch SPEAK: Speaker HD: Hard Drive Activity LED RES: Reset Switch CI: Chassis Intrusion Header (Note) The pin assignments for the front panel header may differ by model. Refer to the motherboard user's manual for the actual pin assignments. [. . . ]