User manual GIGABYTE GA-F2A88X-HD3

[. . . ] 3001 12ME-F288XH3-3001R Motherboard GA-F2A88X-HD3 Motherboard GA-F2A88X-HD3 Aug. The trademarks mentioned in this manual are legally registered to their respective owners. Disclaimer Information in this manual is protected by copyright laws and is the property of GIGABYTE. Changes to the specifications and features in this manual may be made by GIGABYTE without prior notice. No part of this manual may be reproduced, copied, translated, transmitted, or published in any form or by any means without GIGABYTE's prior written permission. [. . . ] Enabled allows the system to simultaneously access different channels of the memory to increase memory performance and stability. (Default: Enabled) && Profile VTT Voltage && Rank Interleaving && Channel Interleaving `` Channel A/B Timing Settings This sub-menu provides memory timing settings for each channel of memory. The respective timing setting screens are configurable only when DRAM Timing Selectable is set to Quick or Expert. Note: Your system may become unstable or fail to boot after you make changes on the memory timings. If this occurs, please reset the board to default values by loading optimized defaults or clearing the CMOS values. `` Advanced Voltage Settings `` PC Health Status && Reset Case Open Status This sub-menu allows you to set CPU, chipset and memory voltages. && Case Open Disabled  Keeps or clears the record of previous chassis intrusion status. (Default) Enabled   Clears the record of previous chassis intrusion status and the Case Open field will show "No" at next boot. Displays the detection status of the chassis intrusion detection device attached to the motherboard CI header. If the system chassis cover is removed, this field will show "Yes", otherwise it will show "No". To clear the chassis intrusion status record, set Reset Case Open Status to Enabled, save the settings to the CMOS, and then restart your system. Displays the current system voltages. && CPU Vcore/DRAM Voltage/+3. 3V/+5V/+12V && CPU/System Temperature && CPU/1st System/2nd System Fan Speed && CPU Warning Temperature Displays current CPU/system fan speeds. When CPU temperature exceeds the threshold, BIOS will emit warning sound. Options are: Disabled (default), 60oC/140oF, 70oC/158oF, 80oC/176oF, 90oC/194oF. Allows the system to emit warning sound if the fan is not connected or fails. Check the fan condition or fan connection when this occurs. (Default: Disabled) Allows you to determine whether to enable the fan speed control function and adjust the fan speed. Normal   Allows the fan to run at different speeds according to the CPU temperature. You can adjust the fan speed with EasyTune based on your system requirements. (Default) - 21 - Displays current CPU/system temperature. && CPU/1st/2nd System Fan Fail Warning && CPU Fan Speed Control (CPU_FAN Connector) && Slope PWM Silent  Allows the fan to run at slow speeds. Manual Allows you to control the fan speed under the Slope PWM item. This item is configurable only when CPU Fan Speed Control is set to Manual. Normal Allows the fan to run at different speeds according to the system temperature. You can adjust  the fan speed with EasyTune based on your system requirements. Manual Allows you to control the fan speed under the Slope PWM item. This item is configurable only when 1st System Fan Speed Control is set to Manual. [. . . ] Step 3: On the next screen, press <Enter> to continue the driver installation. After the driver installation, you can proceed with the Windows XP installation. - 32 - 3-2 Drivers Installation •• Before installing the drivers, first install the operating system. (The following instructions use Windows 8 as the example operating system. ) •• After installing the operating system, insert the motherboard driver disk into your optical drive. [. . . ]