User manual GIGABYTE GA-E350N-USB3

[. . . ] GA-E350N-USB3 FT1 BGA motherboard Built in with an AMD E-350 Dual-Core processor User's Manual Rev. 1001 12ME-E350NB3-1001R Motherboard GA-E350N-USB3 Motherboard GA-E350N-USB3 Dec. The trademarks mentioned in this manual are legally registered to their respective owners. Disclaimer Information in this manual is protected by copyright laws and is the property of GIGABYTE. Changes to the specifications and features in this manual may be made by GIGABYTE without prior notice. [. . . ] PEG SetsthePCIExpressgraphicscardasthefirstdisplay. (Default) Backup BIOS Image to HDD Init Display First BIOS Setup - 38 - 2-6 x Integrated Peripherals CMOS Setup Utility-Copyright (C) 1984-2010 Award Software Integrated Peripherals OnChipSATAController OnChipSATAType OnChipSATA3. 0Support OnChip SATA Port as ESP OnboardLANFunction OnboardLANBootROM SMARTLAN OnboardAudioFunction OnboardUSB3. 0Controller USBControllers USBLegacyFunction USBStorageFunction [Enabled] [NativeIDE] [Enabled] Press Enter [Enabled] [Disabled] [PressEnter] [Enabled] [Enabled] [Enabled] [Enabled] [Enabled] Item Help Menu Level Enter: Select higf: Move F5: Previous Values +/-/PU/PD: Value F6: Fail-Safe Defaults F10: Save ESC: Exit F1: General Help F7: Optimized Defaults OnChip SATA Controller OnChip SATA Type Enables or disables the integrated SATA controller. (Default: Enabled) ConfigurestheoperatingmodeoftheintegratedSATAcontroller. (Default) Enable Native IDE mode if you wish to install operating systems that support Native mode. AHCI ConfigurestheSATAcontrollerstoAHCImode. AdvancedHostControllerInterface (AHCI)isaninterfacespecificationthatallowsthestoragedrivertoenableadvanced Serial ATA features such as Native Command Queuing and hot plug. OnChip SATA3. 0 Support Enables or disables the SATA 6Gb/s function integrated in the FCH. When set to Disabled, the SATA controller will operate in SATA 3Gb/s mode. (Default: Enabled) OnChip SATA Port as ESP CMOS Setup Utility-Copyright (C) 1984-2010 Award Software OnChip SATA Port as ESP Port0asESP Port1asESP Port2asESP Port3asESP [Disabled] [Disabled] [Disabled] [Disabled] Item Help Menu Level Enter: Select higf: Move F5: Previous Values +/-/PU/PD: Value F6: Fail-Safe Defaults F10: Save ESC: Exit F1: General Help F7: Optimized Defaults Port0 as ESP/ Port1 as ESP/ Port2 as ESP/ Port3 as ESP ThisoptionisconfigurableonlywhenOnChip SATA Type is set to AHCI. Enabled will speed up the hot plug detection of the connected SATA device. (Default: Disabled) - 39 BIOS Setup Onboard LAN Function Enables or disables the onboard LAN function. (Default: Enabled) If you wish to install a 3rd party add-in network card instead of using the onboard LAN, set this item to Disabled. Allows you to decide whether to activate the boot ROM integrated with the onboard LAN chip. (Default: Disabled) Onboard LAN Boot ROM SMART LAN (LAN Cable Diagnostic Function) CMOS Setup Utility-Copyright (C) 1984-2010 Award Software SMART LAN Start detecting at Port. . . . . Part1-2 Status = Open Part3-6 Status = Open Part4-5 Status = Open Part7-8 Status = Open / / / / Length Length Length Length = = = = 0m 0m 0m 0m Item Help Menu Level Enter: Select higf: Move F5: Previous Values +/-/PU/PD: Value F6: Fail-Safe Defaults F10: Save ESC: Exit F1: General Help F7: Optimized Defaults This motherboard incorporates cable diagnostic feature designed to detect the status of the attached LAN cable. This feature will detect cabling issue and report the approximate distance to the fault or short. Refer to the following information for diagnosing your LAN cable: When No LAN Cable Is Attached. . . If no LAN cable is attached to the motherboard, the StatusfieldsofallfourpairsofwireswillshowOpen and the Lengthfieldsshow0m, asshowninthefigureabove. If no cable problem is detected on the LAN cable connected to a Gigabit hub or a 10/100 Mbps hub, the following message will appear: Start detecting at Port. . . . . LinkDetected-->100Mbps CableLength= 30m Link Detected Displays transmission speed. Cable Length Displays the approximate length of the attached LAN cable. Note: The Gigabit hub will only operate at a speed of 10/100 Mbps in MS-DOS mode; it will operate at a normal speed of 10/100/1000 Mbps in Windows mode or when the LAN Boot ROM is activated. Ifacableproblemoccursonaspecifiedpairofwires, theStatusfieldwillshowShort and then length shown will be the approximate distance to the fault or short. Example: Part1-2 Status = Short / Length = 2m Explanation: A fault or short might occur at about 2m on Part 1-2. Note: Part 4-5 and Part 7-8 are not used in a 10/100 Mbps environment, so their Statusfieldswillshow Open, and the length shown is the approximate length of the attached LAN cable. BIOS Setup - 40 - Onboard Audio Function Enables or disables the onboard audio function. [. . . ] Is the power connector of the CPU cooler connected to the CPU_FAN header properly?Yes Yes Isolate the short circuit. Theproblemisverifiedandsolved. Connect the CPU cooler power cable to the motherboard. Theproblemisverifiedandsolved. No Correctly insert the memory into the memory socket. Check if the memory is installed properly on the memory slot. [. . . ]