User manual GEONAUTE WATCH KRONYS 500W

[. . . ] -The guarantees contained here replace all other guarantees including the implicit guarantee of fair and trade quality and/or adaptation to use. GEONAUTE cannot under any circumstances be held responsible for any damage, be it direct or indirect, general or specific, caused by or linked to these directions for use or the products they relate to. -During the warrantee period, the item will either be repaired free of charge by an authorized repair service or replaced for free (depending on distributor). -The guarantee does not cover batteries or cracked or broken casings where signs of a blow are evident. 16 17 Dista F100 TLL 24/07/06 16:01 Page 18 USE/PRECAUTIONS FOR USE Description of normal conditions of use Wear this pedometer as close as possible to your body's center of gravity, just to the right or left of your belt buckle. [. . . ] To ensure reliable readings, it is important to maintain a regular pace and stride. The technology of the pedometer limits its use in rugged terrain. Description of the device 1. SET button For setting each mode 4 RESET button To reset the different display modes. For attaching the device to your belt or clothing Restrictions on use/precautions for use - Do not immerse in water. If the device comes into contact with water, wipe it with a soft, dry, non-plush cloth. - Do not subject to shocks or expose to dust or extremes of temperature and humidity. - Only use new batteries of the type indicated in this owner's manual. Do not mix new and used batteries, because this may damage the device. Recycling The " crossed-out wastebasket "symbol indicates that this product and the batteries it contains should not be thrown away with household waste. Deposit the batteries and your unusable electronic product in an authorized collection area for recycling. Press on the MODE button to display the various modes: STEP: number of steps taken DIST: distance covered (equal to the number of steps multiplied by the length of stride you enter) KCAL: number of calories consumed during exercise To reset one of the modes, press for 2 seconds on the RESET button. The other modes will be reset at the same time. Specifications 12/24 time with HH/MM/SS display Step counter from 0 to 999, 999 steps Distance covered from 0 to 9, 999. 99 km (0 to 6, 209. 99 miles) Step length from 15 to 200 cm (6 to 79 inches) Weight range from 20 to 200 kg (44 to 440 lb) Calories consumed from 0 to 9, 999 KCAL (resolution : 1 KCAL) Operating temperature -10°C to 40°C Storage temperature -20°C to 60°C Power supply : 1 LR44 1. 5V battery TECHNICAL DATA Changing the battery The device runs on one LR44 1. 5 V battery To change an old battery : 1. Note: Protect the environment by disposing of your used batteries at appropriate collection points. 24 25 Dista F100 TLL 24/07/06 16:01 Page 26 Problems encountered 1 Nothing is displayed on the screen Possible causes 1. 1 There may be no battery in the device. Launch an automatic troubleshooting procedure on the device, referring to the "Factory mode" section. If the procedure does not run properly, bring the device back to the store nearest you. If the procedure runs properly, change the battery, referring to the "Changing the battery" section. 2 The product is malfunctioning or part of the screen is blank 3. 1 The device may be positioned incorrectly. Ideally, it should be placed and worn on your belt (as close as possible to your center of gravity). First, make sure that the pendulum mechanism (step counting sensor) of the device is functioning properly : Put the device in STEP mode Hold the device straight with the screen upright, in your hand Swing your arm up and down (1~2 per second) 3 When you walk, the number of Check on the screen if the number of steps goes up steps does not increase 3. 2 Your walking pace is not high enough for the pedometer to detect your steps. In this case, contact your retailer to check the sensitivity of the device. [. . . ] First, make sure that the pendulum mechanism (step counting sensor) of the device is functioning properly : Put the device in STEP mode Hold the device straight with the screen upright, in your hand Swing your arm up and down (1~2 per second) 3 When you walk, the number of Check on the screen if the number of steps goes up steps does not increase 3. 2 Your walking pace is not high enough for the pedometer to detect your steps. In this case, contact your retailer to check the sensitivity of the device. To check if the device works properly when you walk fast: put the device in STEP mode Next, attach the device to your belt, in an upright position Walk at a fast pace and check on the screen if the number of steps goes up 4. 1 The device does not directly measure the distance covered. The accuracy for the distance covered is +/10%, depending on the length of step and the type of exercise done. [. . . ]