User manual GENIUS SOUNDMAKER VALUE 5.1 PCI

[. . . ] However, there is no guarantee that interference will not occur in a television reception, which can be determined by turning the equipment off and on, the user is encouraged to try and correct the interference by one or more of the following measures: Reorient or relocate the receiving antenna Increase the separation between the equipment and the receiver Connect the equipment into an outlet on a circuit different from that to which the receiver is connect to CAUTION! The Federal Communication Commission warns the user that changes or modifications to the unit not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment. 1 PCI Sound Card－Sound Maker Value 4. 1/5. 1 Sound Card 1. Overview 1. 1 Sound Maker Value 4. 1 Features Chipset： CMI8738 / PCI-SX 4Ch form C-Media Technology System Interface： 32bit PCI Bus Master, PCI 2. 1 compliant Hardware Interface： Newest single chip 4 channel PCI sound audio (Plug and Play (PnP)) solution HRTF-base 3D positional audio, supporting DirectSoundTM3D, A3D interface Support multi-speaker output to 2 / 4 speakers Support EAXTM, Karaoke Echo, key Surround sound High Performance Dual Game Port MPU401 compatible MIDI interface Comply with Microsoft® PC99 specification DLS-base Wavetable music synthesizer, supporting Direct Music® Fully Sound Blaster, Sound Blaster Pro compatible and Direct Sound compatible Full-duplex playback and recording Connector： Front-Out, Rear-Out, Line-In, MIC-In and Game/MIDI port CD Audio, AUX Connector System Requirements IBM compatible PC with 32-bit PCI slot. Microsoft® Windows® 98/98SE/Me/2000/XP/NT4. 0/DOS or Linux Intel® Pentium® 166MHz CPU above (Recommended) 32 MB system memory (Minimum) 100 MB available HDD space CD-ROM drive (or DVD-ROM drive Recommended) Software Bundle Multi-channel Speaker Tester Powerful Audio Rack (CD / Midi / Wav / MP3 Player ) Package Plug and Play PCI sound card User manual “Installation Software” CD-ROM 2 PCI Sound Card－Sound Maker Value 4. 1/5. 1 Sound Card 1. 2 Sound Maker Value 5. 1 Features Chipset： CMI8738 / PCI-6Ch form C-Media Technology System Interface： 32bit PCI Bus Master, PCI 2. 1 / PCI 2. 2 compliant Hardware Interface： Newest single chip 5. 1 channel PCI sound audio solution HRTF-base 3D positional audio, supporting DirectSoundTM3D, EAX™ and A3D interface Karaoke system enabled Supports multi-speaker output to 2 / 2. 1 / 4 / 4. 1 / 5. 1 speakers Support EAXTM, Karaoke key, Echo… sound effects High Performance Dual Game Port MPU401 compatible MIDI interface & GM Comply with Microsoft® PC99 specification DLS-base Wavetable music synthesizer Fully Sound Blaster, Sound Blaster Pro compatible and Direct Sound compatible Connector： Front-Out, Rear-Out, Center & LFE, Line-In, MIC-In and Game/MIDI port CD Audio, AUX Connector System Requirements IBM compatible PC with 32-bit PCI slot. Microsoft® Windows® 98/98SE/ Me/ 2000/ XP/ NT4. 0 / DOS or Linux Intel® Pentium® II 366MHz CPU above (Recommended) 32 MB system memory (Minimum) 100 MB available HDD space CD-ROM drive (or DVD-ROM drive Recommended) Software Bundle Multi-channel Speaker Tester WinDVD™ (Option) Powerful Audio Rack (CD / Midi / Wav / MP3 Player ) Package Plug and Play PCI sound card User manual “Installation Software” CD-ROM 3 PCI Sound Card－Sound Maker Value 4. 1/5. 1 Sound Card 2. Hardware Installation Before you start, make sure that Windows® 98/98SE, Windows® Me, Windows® 2000/XP, Windows NT® 4. 0 or Linux has been installed in your system and running properly. [. . . ] If Auto Run can’t be used with your computer, please refer to each Windows as follows, Installing the Sound Card Driver under Windows® 98/98SE 1. After hardware installation has been finished, power up your computer and wait for Windows® 95/98/98SE to boot up. The message box will show “Add New Hardware Wizard” and “This Wizard searches for new drivers for PCI Multimedia Audio Device”. Insert the Multimedia Software CD-ROM into your CD-ROM drive or DVD-ROM drive. Key in the drive and path for drivers/application installation program; for example, “D:\SMVALUE4. 1\SETUP. EXE” or “D:\SMVALUE5. 1\SETUP. EXE”. Click “OK” to start the applications/driver installation procedure, and follow the on-screen instructions to finish the installation. When all the application software has been installed, please restart your computer. Your system will install device drivers automatically. Installing the Sound Card Driver under Windows® Me 1. After hardware installation has been finished, power up your computer and wait for Windows® Me to boot up. The message box will show “Add New Hardware Wizard” and “Windows has found the following new hardware for PCI Multimedia Audio Device”. Insert the Multimedia Software into your CD-ROM drive or DVD-ROM drive. Key in the drive and path for drivers/application installation program; for example, “D:\SMVALUE4. 1\SETUP. EXE” or “D:\SMVALUE5. 1\SETUP. EXE”. Click “OK” to start the applications/driver installation procedure, and follow the on-screen instructions to finish the installation. When all drivers have been installed, your system will continue to install the application software. When all the application software has been installed, please restart your computer. Installing the Sound Card Driver under Windows® 2000/XP We recommend you to install Microsoft® Windows® before you install this PCI sound card, and ensure you didn’t install any other sound card device drivers in your current system. After hardware installation has been finished, power up your computer and wait for Windows® 2000 to boot up. The message box will show “Found New Hardware Wizard” Click “Cancel”. Insert the Multimedia Software into your CD-ROM drive or DVD-ROM drive. [. . . ] Click “OK” to start the installation procedures, and follow the on-screen instructions to finish the installation. When all of application software has been installed, shut down the Windows NT® system and then reboot your system. Uninstalling the Sound card Driver for Windows NT® 4. 0 1. Select "Audio for C-Media PCI Device" then press "Remove" button. Shut down NT system and reboot. Installing the Sound Card Driver under Linux 1. [. . . ]