User manual GENIUS REMOTE 600

[. . . ] 26 Troubleshooting . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 27 ii ENGLISH Chapter 1 Introducing the Remote 600 Congratulations on purchasing the Remote 600 Touch Screen Remote Control. The Remote 600 is a digital universal remote control that is easy to use and enables you to control all your electronic devices equipped with an infrared (IR) remote. You can control up to six devices, including VCRs, DVDs, TVs, and satellite receivers. [. . . ] Please replace batteries to enter setup. 10 ENGLISH Changing the LCD layout You can customize the LCD layout to match the remote control supplied with your devices. Press and hold for two seconds the device button of the device you want to customize. As you press the button repeatedly, the various labels for the button appear. to save the changes or to discard them. 11 ENGLISH Using preset codes This is the fastest way to program the Remote 600 but requires that your device be located in the Pre-programmed Code List that was bundled with the Remote 600. Some newer or less common devices may not be pre-programmed and their codes must be learned using the learning function of the Remote 600. See Manually setting preset codes on page 13. 12 ENGLISH Manually setting preset codes 1. (Refer to the pre-programmed code list table) After you enter the last digit, a double beep sounds, confirming the code has been input. If the number isn't in the code database, the Remote 600 will beep three times continuously. Check you have entered the correct code by pressing Volume +/­, Channel +/­ or . See Checking the code number on page 14 13 ENGLISH Checking the code number After automatically setting a preset code, you can find the code's number using the following procedure. This is useful if your settings are accidentally erased in the future. While holding the device button, press and hold the "1" button. Repeat this by pressing 2, 3, and 4 for the second, third and forth digits of the code number. You can use this code number to program the Remote 600 if your settings are changed or accidentally erased. See Manually setting preset codes on page 13. Code Number 5 14 ENGLISH Learning codes If your device is not in the list of preset codes, you can use your existing IR remote control to "teach" the Remote 600. If the Remote 600 cannot learn a code, three beeps are emitted. 1. Set both remotes on a flat surface with the target device's remote control pointed at the Remote 600's learning eye, for about 5 ~10 cm apart. On the Remote 600, press the device button of the device you want to program. On the Remote 600, press the button to indicate the key you want to program. Press the device button to switch between touch screen pages. 15 ENGLISH 6. Aim the IR transmitter of your device's remote control at the learning eye of the Remote 600. Continually press the corresponding button on your existing remote control until the Remote 600 LED lights. [. . . ] *The record button has a safety feature to prevent accidental operation. *Check the target device's remote is correctly aimed at the Remote 600's learning eye and keep distance between remotes to about 5~10 cm. *Check you are holding the target remote's button until the LED lights up to confirm this function is learned. *Do not teach the Remote 600 near candescent lights. The VCR, Hard disk recorder, or DVD will not record. [. . . ]