User manual GENIUS 1812HR

[. . . ] Status LED: Shows the "Power, Status, Mode" of NewSketch 1212HRIII. Reset: Resets the communication data for NewSketch 1812HR The Stylus of NewSketch 1212HRIII There are three buttons on the stylus. [. . . ] Plug the 9-pin connector of the interface cable into the host communications port. If the computer has a 25-pin serial port, connect the 9-to-25 pin adapter between the tablet cable and the computer. The tablet is now ready to operate once you have installed the driver. Installing NewSketch 1812HR Follow these steps to install your NewSketch 1812HR tablet. Plug the 9-pin connector of the interface cable into the host communications port. If the computer has a 25-pin serial port, connect the 9-to-25 pin adapter between the tablet cable and the computer. Make sure you have the correct power adapter according to the electrical standards in your country. Connect the power adapter by plugging its barrel connector into the interface cable D connector. The tablet is now ready to operate once you have installed the driver. Driver Installation For both models: Follow these procedures to install the Genius Tablet driver when using Windows. When the installation is complete, restart your computer to activate your tablet. Tablet Control Panel Allows you to setup and test all functions of the pointing device. [. . . ] Test Folder: Click your stylus or puck in this area to see if the settings are correct or not. Note: If you change your pointing device, press the "Reset" button and restart your PC. [. . . ]