User manual GENI ELECTRONICS ZAP STROBE FL-75P

[. . . ] Zap Strobe TM FL-45P FL-75P FL-150P , , Have a Blast with Zap The Powerfully Stylish Strobe CAUTION! ã Copyright 2002 Geni Electronics Co. , Ltd. Please visit http://www. geni. com. tw for updates. Risk of electric shock Read instructions before installing or connecting to power Congratulations! Thank you for buying a Geni product, and congratulations!With the Geni mark, you are ensured of high quality and reliability for years to come. [. . . ] Y Disconnect from power source at least five minutes before removing lens cover or servicing. Electric charge remains briefly after unit is disconnected from electric power supply. Y Disconnect mains power supply immediately if strobe falls or is struck. About Zap Strobes ZAPTM Strobes deliver a powerful flash -- with either manual or remote control. Their stylish, lightweight case is ideal for mobile light shows or installations. Zap Strobe models FL-45P FL-75P and FL-150P are very similar in construction: , Their main difference is varying lamp wattage. Geni products are inspected at the factory and shipped in perfect condition. If damage occurred in transport, please contact your Geni dealer immediately. Use a 5-kg rated C-clamp to secure the strobe bracket (A2) to trussing. The angle guide (A8), showing degrees of slant, is there for reference. TM TM TM TM 5 2 Zap TM Strobe, Illustration A A1 A1 - Hole for C-clamp A2 - Bracket A3 - Clasp A4 - Lens A5 - Strobe Body A6 - Back Panel (Details on Page 4) A6 A7 - Bracket Knob A8 - Angle Guide A3 A2 A4 Back Panel, Illustration B A5 A7 A8 B1 - Product Specification Area B2 - Certification Mark Area B3 - Serial Number Area B4 - Speed Adjustment Knob B5 - Signal IN Connection B6 - Signal OUT Connection B7 - Mains Power Line Note: Look at the Product Specification Area to see which strobe version you have and to know which instructions you should follow. B1 B3 B4 B5 B6 B2 B7 Manual Control Operation 1. Link the strobe to an analog strobe controller, for example, Geni FL-01C or FL34C, as follows: A. Plug one end of a standard microphone cable with 1/4-inch mono jacks to the controller output socket. Insert the 1/4-inch mono jack into the ZapTM Strobe's IN (B5) socket. Insert another cable with 1/4-inch mono jacks into the first strobe unit's OUT (B6) socket. [. . . ] Use rubbing alcohol and a lint-free cloth to wipe lamp tube clean if it is accidentally touched. Align the lens and body: A knob in the lens fits nicely into a slot in the body. Turn the lens counterclockwise on the body, bringing the screw hole on the clasp (A3) into place. [. . . ]