User manual GENERAL ELECTRIC 380000 MANUAL 2011

[. . . ] This manual contains safety information to make you aware of the hazards and risks associated with engines and how to avoid them. It also contains instructions for the proper use and care of the engine. Because Briggs & Stratton Corporation does not necessarily know what equipment this engine will power, it is important that you read and understand these instructions and the instructions for the equipment. For replacement parts or technical assistance, record below the engine model, type, and code numbers along with the date of purchase. [. . . ] Do not tamper with governor spring, links or other parts to increase engine speed. replacement parts must be of the same design and installed in the same position as the original parts. Other parts may not perform as well, may damage the unit, and may result in injury. Do not strike the flywheel with a hammer or hard object because the flywheel may later shatter during operation. First 5 Hours Change oil Every 8 Hours or Daily Every 100 Hours or Annually Clean or change air filter * Change engine oil and filter Replace spark plug Check muffler and spark arrester Every 250 Hours or Annually Every 400 Hours or Annually Clean air cooling system * Clean oil cooler fins * Check engine oil level Clean area around muffler and controls In dusty conditions or when airborne debris is present, clean more often. Note: In some areas, local law requires using a resistor spark plug to suppress ignition signals. If this engine was originally equipped with a resistor spark plug, use the same type for replacement. Dirt or debris can restrict air flow and cause the engine to overheat, resulting in poor performance and reduced engine life. Keep the area around and behind the muffler (C) free of any combustible debris (Figure 7). When Storing Fuel Or Equipment With Fuel In Tank Store away from furnaces, stoves, water heaters or other appliances that have pilot lights or other ignition sources because they can ignite fuel vapors. 5% for each 1, 000 feet (300 meters) above sea level and 1% for each 10 F (5. Service Part Air Filter -- model 290000, 300000 Air Filter -- model 350000, 380000 Air Filter Pre-cleaner Oil -- SAE 30 Oil Filter -- 6 cm long N We recommend that you see any Briggs & Stratton Authorized Dealer for all maintenance and service of the engine and engine parts. Briggs & Stratton Corporation will repair or replace, free of charge, any part(s) of the engine that is defective in material or workmanship or both. Transportation charges on product submitted for repair or replacement under this warranty must be borne by purchaser. This warranty is effective for and is subject to the time periods and conditions stated below. For warranty service, find the nearest Authorized Service Dealer in our dealer locator map at BRIGGSandSTRATTON. cOM , or by calling 1-800-233-3723 , or as listed in the `Yellow Pages'. Implied warranties, including those of merchantability and fitness for a particular purpose, are limited to one year from purchase, or to the extent permitted by law. liability for incidental or consequential damages are excluded to the extent exclusion is permitted by law. Some states or countries do not allow limitations on how long an implied warranty lasts, and some states or countries do not allow the exclusion or limitation of incidental or consequential damages, so the above limitation and exclusion may not apply to you. This warranty gives you specific legal rights and you may also have other rights which vary from state to state and country to country. 3 years 2 years 3 years 1 year Extended Life Seriest; I/C®; Intekt I/C®; Intekt Pro; Commercial Turf Seriest Professional Seriest with Dura-Boret Cast Iron Sleeve; 850 Seriest with Dura-Boret Cast Iron Sleeve; Snow Series MAXt with Dura-Boret Cast Iron Sleeve All Other Briggs & Stratton Engines Featuring Dura-Boret Cast Iron Sleeve All Other Briggs & Stratton Engines These are our standard warranty terms, but occasionally there may be additional warranty coverage that was not determined at time of publication. [. . . ] Any such Fuel line, fuel line fittings, clamps part repaired or replaced under warranty will be warranted for the remaining Fuel tank, cap and tether warranty period. carbon canister Any warranted part that is scheduled for replacement as required maintenance b. Air Induction System in the owner's manual supplied, is warranted for the period of time prior to the Air cleaner first scheduled replacement point for that part. If the part fails prior to the first Intake manifold scheduled replacement, the part will be repaired or replaced by B&S at no Purge and vent line charge to the owner. [. . . ]