User manual GEHA S5

[. . . ] Before using the device for the first time, carefully read this manual. IMPORTANT SAFETY NOTES Before using the document shredder for the first time, please read the operating instructions. [. . . ] Do not clean the shredder with cloth or detergents containing aerosols or solvents. The shredder is equipped with a safety switch interrupting the power supply as soon as the cutting unit is removed from the bin or when it is not correctly placed on it. Set the sliding switch to AUTO to activate automatic paper intake as soon as a document is placed in the feeder slot, triggering the release switch in the feeder opening. If the sliding switch is set to OFF, the shredder does not automatically start up when a document is placed in the feeder opening. We recommend setting the switch to this position when the shredder is not in use. set the sliding switch to REV , if you wish to operate the shredder continuously in reverse mode. PREVENTING PAPER JAMS AND OVERLOADING The S5 can shred up to 5 sheets (DIN A4, 70g/m²) at a time and can handle documents of up to 220mm in width. If you wish to shred smaller pieces of paper such as envelopes and sales receipts, insert them at the centre of the feeder slot to ensure that the switching sensor is triggered. A normal operating cycle for shredding at maximum load takes 2 minutes, which must be followed by a break in operation. The power supply to the shredder motor is automatically interrupted in the following cases: 1. Simultaneous insertion of more than 5 sheets of paper (DIN A4, 70g/m²) or feeding of paper in a direction other than longitudinal. Under the above conditions, the automatic overload circuit breaker of the motor might be triggered, interrupting the power supply to the device. Disconnect the power plug from the mains socket and wait for a minimum of 60 minutes until the overload circuit breaker is automatically reset. Remove the paper by pulling it upwards out of the cutting unit and tear off any excess paper. [. . . ] Aparatul dispune de un întreruptor de siguran care permite întreruperea alimentrii cu curent electric imediat ce unitatea de tiere este îndeprtat de pe recipientul de colectare a hârtiei sau în cazul în care unitatea de tiere nu a fost corect fixat. Aceasta manevr este necesar pentru situaiile în care se dorete eliminarea hârtiei care a produs un blocaj la alimentator. [. . . ]