User manual GEHA OFFICE X8

[. . . ] When operating an electrical device, you should always take basic safety measures to eliminate the risk of injury from electric shock. This device is exclusively designed for shredding paper, so do not use it for any other purposes. Never insert films, OHP films, label paper, clothing or plastics into the shredder. [. . . ] 4 Shredding unit 5 Protective lid 6 Paper bin The paper bin was specially developed for this device. Make sure the switch is turned to "AUTO", place the shredding unit onto the bin correctly. To cut small pieces of paper such as envelopes and cash vouchers, insert them at the centre of the feeder slot in order to active the switch-on sensor. The device starts when the sensor is activated, and switches off two seconds after the paper was cut. It stops as soon as the switch is set to "AUTO" or the motor is overheated (red light comes on). When set to this position, the device eliminates jammed paper in reverse direction. Otherwise, the device will switch off when the motor is overheated (red light comes on). After removing any excess paper from the shredding unit, set the switch to "AUTO", and continue shredding. Note: Should it not be possible to solve your problem in the manner described, pull the plug and contact your dealer or the manufacturer. To empty the paper bin, set the switch to "AUTO" and pull the plug. After emptying the bin, be sure to place the shredding unit on the bin in the correct position. MAINTENANCE Pull the plug before any maintenance work is carried out! ) · The out parts of the device are made of plastic materials. Therefore, do not use solvents such as benzine or benzol, or any organic solvents such as thinner. [. . . ] Make sure the quantity does not exceed the maximum shredding capacity. Should the device not operate after carrying out the troubleshooting measures outlined above, unplug and contact your dealer. X8 mal ned upp till 8 vikta blad (DIN A4, 70g/m²) och bearbetar bredder upp till 220 mm. [. . . ]