User manual GEHA OFFICE X7 CD

[. . . ] ImPorTaNT NoTEs oN safETy Please read the user manual carefully and in its entirety before commissioning the file shredder. When using electric devices, always take basic precautions to eliminate any risk of injury. This file shredder has been designed specifically for the shredding of paper and CDs. [. . . ] Once all paper has been shredded and no additional paper is fed into the machine, the device stops automatically (Standby Mode). If you have fed 4 - 7 sheets of paper (A4, 70 g/m²) into the device, the machine will consume more power and the LED `Economy` will not light up. An automatic reverse and stop function prevents a paper jam when the device is overloaded with too much paper in the feeder. Should a paper jam occur, remove all paper from the feeder and wait until the device has finished its automatic cleaning process and has stopped operating. `fWD` If you place a narrow piece of paper (< 10 cm) into the feeder sideways, then the photoelectric barrier may not detect it and thus not start the device automatically. In that case, press and hold the button: `FWD`, until the paper has been drawn in completely. `rEv` By pressing the button: `REV`, you can initiate the reverse operation of the cutting mechanism in case of a paper jam. When the sensor detects that the waste paper container is full, the device will stop automatically, and the viewing window in the waste paper container will be illuminated in blue. First remove all paper from the feeder, and then empty the waste paper container. Feeding cDs/DvDs and credit cards into the shredder This device is equipped with a separate cutting mechanism for CDs/DVDs and credit cards. switch on the file shredder by pressing the power button on the rear of the device. CDs/DVDs und credit cards are detected automatically in the CD slot, and the device activates. Make sure to keep your face well away from the feeder slot when shredding CDs/DVDs, since these types of material always pose a hazard of splintering! the shredded material is collected in a separate waste receptacle to facilitate environmentally friendly disposal. Important note: The device will switch off automatically if the motor temperature increases too much. the LED `status` will light up red (overheating) and signals that the overheat protection of the device has been activated. If that is the case, the device will not react when you press the button `rEv` or `fWD`. Once the motor has cooled down sufficiently, the device will switch back into normal operating mode, and the LED `status` will light up green. [. . . ] DIsPosaL The symbol depicting a crossed-out rubbish bin means that electrical devices may not be disposed of with regular household waste. please bring the device to an approved recycling centre for environmentally firendly disposal. Make sure to keep both your proof of purchase and the original packaging. [. . . ]