User manual GEHA OFFICE X12 CD

[. . . ] ImPorTaNT NoTEs oN safETy Please read the user manual carefully and in its entirety before commissioning the file shredder. When using electric devices, always take basic precautions to eliminate any risk of injury. This file shredder has been designed specifically for the shredding of paper and CDs. Do not attempt to feed foils, adhesive labels, clothing, or plastic materials into the file shredder. [. . . ] Once all paper has been shredded and no additional paper is fed into the machine, the device stops automatically (Standby Mode). An automatic reverse and stop function prevents a paper jam when the device is overloaded with too much paper in the feeder. Should a paper jam occur, remove all paper from the feeder and wait until the device has finished its automatic cleaning process and has stopped operating. `fWD` If you place a narrow piece of paper (< 10 cm) into the feeder sideways, then the photoelectric barrier may not detect it and thus not start the device automatically. In this case, press and hold the button `FWD` until the paper has been drawn in completely. `rEv` By pressing the button `REV`, you can initiate the reverse operation of the cutting mechanism in case of a paper jam. When the sensor detects that the waste paper container is full, the device stops automatically and the red LED `Bin Full` lights up, and the LCD display will show `Basket Full`. First remove all paper from the feeder, and then empty the waste paper container. Feeding cDs/DvDs, credit cards and floppy Disks into the shredder This device is equipped with a separate cutting mechanism for CDs/DVDs, credit cards and floppy disks. switch on the file shredder by pressing the power button on the rear of the device. The green LED `Power` lights up, and the operating mode (Ready) and current time are shown in the LED display. Any CDs/DVDs, credit cards and floppy disks in the CD slot are detected automatically, the device starts up and the operating mode `In Use` is shown on the LCD display. CDs/DVDs, credit cards and floppy disks are shredded into 10 mm wide strips. Make sure to keep your face well away from the feeder slot when shredding CDs/DVDs, since these types of material always pose a hazard of splintering!By pressing the button `FWD`, you can now increase the hour displayed, and by pressing the button `REV` you can decrease the hour displayed. By pressing the button `FWD`, you can now increase the minutes displayed, and by pressing the button `REV` you can decrease the minutes displayed. Important note: The device will switch off automatically if the motor temperature increases too much. The red LED `overheat` lights up and signals that the overheat protection of the device has been activated the LcD display shows `Please Wait`. If that is the case, the device will not react when you press the button `rEv` or `fWD`. The device switches back into normaloperation as soon as the motor has cooled sufficiently. [. . . ] DIsPosaL The symbol depicting a crossed-out rubbish bin means that electrical devices may not be disposed of with regular household waste. please bring the device to an approved recycling centre for environmentally firendly disposal. Make sure to keep both your proof of purchase and the original packaging. Se till att pappersbehållaren är inskjuten till anslag i apparaten. [. . . ]