User manual GE SIDE-BY-SIDE REFRIGERATOR 27

[. . . ] Write the model and serial numbers here: Model # __________________________ Serial # __________________________ Find these numbers on a label inside the refrigerator compartment at the top on the right side. Use this appliance only for its intended purpose as described in this Owner's Manual. When using electrical appliances, basic safety precautions should be followed, including the following: I This refrigerator must be properly installed and located in accordance with the Installation Instructions before it is used. I Do not allow children to climb, stand or hang on the shelves in the refrigerator. [. . . ] After replacing the bulb with an appliance bulb of the same or lower wattage, replace the light shield and screw. When replacing the light shield, make sure that the tabs at the back of the shield fit into the slots at the back of the light shield housing. After replacing the bulb with an appliance bulb of the same or lower wattage, replace the shield. Replace the bulb with an appliance bulb of the same or lower wattage, and reinstall the light shield. When reinstalling the light shield, make sure the top tabs snap securely into place. There is an LED lighting display in the top of the refrigerator compartment on some models. A GE water supply kit (containing tubing, shutoff valve, fittings and instructions) is available at extra cost from your dealer, by visiting our Website at ge. Note to Installer ­ Be sure to leave these instructions with the Consumer. Note to Consumer ­ Keep these instructions for future reference. Skill level ­ Installation of this appliance requires basic mechanical skills. If the refrigerator has already been installed, remove the base grille (see Step 2 in Moving the Refrigerator), then skip to Step 5 in Installing the Refrigerator. Leave all tape and door pads on doors until the refrigerator is in its final location. Center the refrigerator on the hand truck and secure the strap around the refrigerator. If the refrigerator must go through any entrance that is less than 38 wide, the doors must be removed. If all entrances are more than 38 wide, skip to Installing the Refrigerator. If the refrigerator has a water dispenser, there is a water line from the cabinet into the bottom hinge on the freezer door that must be disconnected. To disconnect, push in on the white collar of the coupling and pull out the tubing. If the refrigerator has a water dispenser, there is a power line (harness) from the cabinet into the bottom hinge on the freezer door that must be disconnected. A Remove the freezer door top hinge cover by either squeezing it and pulling it up or by prying it off with a plastic putty knife. If the refrigerator has a refreshment center, there are electrical connectors (harnesses) from the cabinet into the bottom hinge on the refrigerator door that must be disconnected. B Remove the two 5/16 hex head screws, then lift the hinge straight up to free the hinge pin. D As one person slowly lifts the freezer door up and off the bottom hinge, the second person should carefully guide the water line and power line (harness) through the bottom hinge. [. . . ] I Replacement of the light bulbs, if included, or water filter cartridge, if included, other than as noted above. Any implied warranties, including the implied warranties of merchantability or fitness for a particular purpose, are limited to one year or the shortest period allowed by law. This warranty is extended to the original purchaser and any succeeding owner for products purchased for home use within the USA. If the product is located in an area where service by a GE Authorized Servicer is not available, you may be responsible for a trip charge or you may be required to bring the product to an Authorized GE Service location for service. [. . . ]