User manual GE GFMS175EHDG

[. . . ] Write the model and serial numbers here: They are on the label on the front of the dryer behind the door. This symbol alerts you to potential hazards that can kill you or hurt you and others. All safety messages will follow the safety alert symbol and the word "DANGER", "WARNING", or "CAUTION". These words are defined as: Indicates a hazardous situation which, if not avoided, will result in death or serious injury. [. . . ] Damage to your dryer caused by these products is not covered by your warranty. Have a qualified technician vacuum the lint from the dryer once a year. Stainless Steel: To clean stainless steel surfaces use a damp cloth with a mild, nonabrasive cleaner suitable for stainless steel surfaces. The stainless steel used to make the dryer drum provides the highest reliability available in a GE dryer. If the dryer drum should be scratched or dented during normal use, the drum will not rust or corrode. These surface blemishes will not affect the function or durability of the drum. Dryer Interior and Duct: The interior of the appliance and exhaust duct should be cleaned once a year by qualified service personnel. The Exhaust Duct: Inspect and clean the exhaust ducting at least once a year to prevent clogging. The Exhaust Hood: Check with a mirror that the inside flaps of the hood move freely when operating. Before replacing the light bulb, be sure to unplug the dryer power cord or disconnect the dryer at the household distribution panel by removing the fuse or switching off the circuit breaker. 2002 during normal business hours, or purchase appliance bulb 7C7 from your local retailer. Fasten the hinge by installing the other 4 screws and tightening the partially fastened screw above. First partially install top hinge screw in dryer and hang door from it Then secure with all screws b. Align the outer ring in the door and fasten the 6 tapping screws located around the perimeter of the door outlining the gasket. Use the packing material so you don't scratch the finish on the dryer. Back out and remove all 4 leveling legs 2 INSTALL RUBBER PADS TO DRYER BASE Locate the 4 rubber pads in the parts package. Remove the adhesive backing and firmly place over each bracket where you removed the leveling legs. Flatten the product carton to use as a pad to lay the dryer down on its side. Continue using the carton to protect the finished floor in front of the installation location. Align the holes in the left bracket with the holes in the bottom left corner of the dryer. Use a Phillips screwdriver to install the 2 #12 x 1" tapping screws. Repeat the above step with the right bracket on the bottom right corner of the dryer. [. . . ] Products which are not defective or broken, or which are working as described in the Owner's Manual. Any implied warranties, including the implied warranties of merchantability or fitness for a particular purpose, are limited to one year or the shortest period allowed by law. This warranty is extended to the original purchaser and any succeeding owner for products purchased for home use within the USA. If the product is located in an area where service by a GE Authorized Servicer is not available, you may be responsible for a trip charge or you may be required to bring the product to an Authorized GE Service location for service. [. . . ]