User manual GE APPLIANCES WSLS1500

[. . . ] Write the model and serial numbers here: You can find them on a label on the back of the washer. For your safety, the information in this manual must be followed to minimize the risk of fire or explosion, electric shock, or to prevent property damage, personal injury or loss of life. The instructions in this manual and all other literature included with this washer are not meant to cover every possible condition and situation that may occur. Good, safe practices and caution MUST be applied when installing, operating and maintaining any appliance. [. . . ] The discharge height MUST NOT BE LESS THAN 30" nor more than 8' above the base of the washer. The standpipe must be 11/2" minimum inside diameter and must be open to the atmosphere. Note to Installer ­ Be sure to leave these instructions with the Consumer. Skill level ­ Installation of this appliance requires basic mechanical skills. Completion time ­ 1 hour Proper installation is the responsibility of the installer. product failure due to improper installation is not covered under the Warranty. Note ­ This appliance must be properly grounded, and electrical service to the washer must conform with local codes and ordinances and the latest edition of the National Electrical Code, ANSI/NFPA 70. Washer must be installed on firm flooring to minimize vibration during spin cycles. Concrete flooring is best, but wood base is sufficient providing floor support meets FHA standards. Install or store where it will not be exposed to temperatures below freezing or exposed to the weather. This appliance must be supplied with the voltage and frequency indicated on the rating plate (located on the back of the washer) and connected to an individual, properly grounded branch circuit, protected by a 15- or 20-amp circuit breaker or time-delay fuse. If the washer is plugged into the dryer's 115-volt outlet, then the dryer needs to be on a dedicated circuit. CAUTION: Before plugging in washer, read the following electrical requirements. eLECTRICAL REQUIREMENTS For personal safety, do not use an extension cord or adapter plug with this appliance. Do not, under any circumstances, cut or remove the third grounding prong from the power cord. follow National Electrical Codes or prevailing local codes and ordinances. This appliance must be supplied with the voltage and frequency indicated on the rating plate (located on the back of the washer) and connected to an individual, properly grounded branch circuit, protected by a 15- or 20-amp circuit breaker or time-delay fuse. If the electric supply provided does not meet the above requirements, call a licensed electrician. Leveling locks are located at the bottom front of the left and right sides of the washer. Insure proper ground exists before use This appliance must be grounded. In the event of a malfunction or breakdown, grounding will reduce the risk of electric shock by providing a path of least resistance for electrical current. This appliance is equipped with a cord having an equipment grounding conductor and a grounding plug. [. . . ] Some states do not allow the exclusion or limitation of incidental or consequential damages. This warranty gives you specific legal rights, and you may also have other rights which vary from state to state. To know what your legal rights are, consult your local or state consumer affairs office or your state's Attorney General. Please have serial number and model number available when calling for service. [. . . ]