User manual GARDINER TECHNOLOGY UG4100

[. . . ] To program, delete or change any of the four possible telephone numbers. The unit is compatible with all makes of alarm control equipment and is capable of up to three different alarm messages if the control equipment has sufficient outputs available. Once triggered the dialler will call the first telephone number, followed by calls to the other numbers if the call is not answered. [. . . ] If display does not clear call installer. Phase Lock Loop error. No Action the unit will reboot. If display does not clear call installer. No Lock error. No Action the unit will reboot. If display does not clear call installer. Last call was aborted. No Action this message will only be seen when viewing the Last Call Log. Call Aborted. The current call was aborted before the message was passed. Telephone Line fault. Correct any problems with telephone line. Check Last Call Log and contact message recipient. Fail to Speak. Alarm. Call aborted after message had started to play Message Cause Low Power Action The voltage to the unit has fallen below 9. 5V. Call installer. Guardian (Call Recipient) Instructions A Guardian is a person who will receive an alarm call from the dialler. You must make sure that all Guardians are aware that they may receive a call from your system and agree what action that they should take in the event of them receiving an alarm notification. In the case of intruder or PA alarms the Guardian should take adequate steps to ensure his/her own safety as the intruder may still be on the premises. Direct calls to UK emergency services are not allowed (please check for other countries) and the facility of programming their number has been blocked. If you have programmed the Acknowledgement feature to On please inform the Guardians you have done so. With this feature the Guardian MUST have a DTMF (Tone type) telephone. This may be determined by lifting the handset of their telephone and pressing a key, if a tone is heard the telephone is DTMF, if a clicking sound is heard it is not. 1) When the call is answered a series of `Granny Tones' (single blips) will be heard for two seconds. The Speech Dialler will then pass its Common Message (usually address) followed by the Short Message (usually type of alarm). If Call Acknowledge is off, the Speech Dialler will shut down and the Guardian should then take the agreed action. Or 4) If Call Acknowledge is On the Speech Dialler will give a tone after the message has been passed, the Guardian should acknowledge this tone by pressing the # key on the telephone for at least one second. [. . . ] When the Dialler is triggered from say trigger 1 it would dial the Guardian and then pass the Common Message followed by Short Message 1 or if it was triggered from trigger 2 it would dial the Guardian and then pass the Common Message followed by Short Message 2. To program/re-program/delete the messages. 1) 2) 3) Enter what Message you wish to program from the list below Display will be flashing Choose 9 for Common Message Choose 1 for Short Message 1 Choose 2 for Short Message 2 Choose 3 for Short Message 3 4) If you wish to delete the existing message press Then return to step 2. or To program/re-program the message press 5) You should now speak your message into the unit at a distance of approximately six inches (15cm) away If your message is shorter than the recording time allowed you may terminate the recording by pressing This will return you to step 2. [. . . ]