User manual GAMES NINTENDO SUPER NES SUPER MARIO WORLD

[. . . ] Hooking up the system with the mains lead plugged in may cause the system to malfunction. The system cable is used to send signals and electricity between the components for interlinked operation. Be sure to insert the connector horizontally until it clicks into place. â· Keep the system cable away from the aerials to prevent noise or malfunction. [. . . ] To select track number 11 and higher Press >10 once and then the number buttons of the track number. Repeat step 3 to select the tracks to be recorded on the side where recording is to start. "P" appears and the total playing time display changes to "0m00s". With manual recording, you can record just the portions you like from a CD on a tape. If you select both sides recording and the tape reaches the end of the front side partway through a track, the entire track is recorded again from the beginning of the reverse side. When you start recording from the reverse side, the recording stops at the end of the reverse side even though you select h. When the recording is completed, the CD player stops and the tape deck pauses automatically. When you want to reduce the hiss noise in highfrequency signals recorded at low level, press DOLBY NR after step 10 so "DOLBY NR" appears in the display. Turning DOLBY NR on reduces the noise when playing back these types of signals. Press DIRECTION repeatedly until g appears to record on one side or h (or j) to record on both sides. When you start recording from the reverse side, the recording stops at the end of the reverse side even though you select h. t 80min T 90min T * The system automatically turns off in 100 minutes, or after the current CD or tape finishes playing. To wake up to the radio, preset the radio stations first (see page 24). note To wake up to an MD, you can use the optional MD deck MDS-SP55 only. Or > repeatedly to select the desired sound source, then press ENTER/YES. the indication changes as follows: t TUNER y CD PLAY T t TAPE PLAY y MD PLAY* T * Select this to use the optional MD deck MDS-SP55 as the sound source. When you press ENTER/YES, the start time, the stop time and the sound source appear in turn, before the original display returns. To timer record, you must first preset the radio station (see page 24) and set the clock (see page 8). You can make a timer recording of a radio programme or the audio signal from a component connected to AUX IN (see page 35). Do not operate the system from the time the system turns on until the play starts (about 30 seconds before the preset time). â· If the system is on at the preset time, the set sound source starts playing. Or > repeatedly until "SET TAPE REC" (or "SET MD REC" when using the optional MD deck MDS-SP55) appears, then press ENTER/YES. [. . . ] However, be careful not to cover the detector slots which allow the tape deck to automatically detect the type of tape. If you have any problem using this system, use the following checklist. First, check that the mains lead is connected firmly and that the speakers are connected correctly and firmly. When bringing the system in for repairs, be sure to bring in the entire system. [. . . ]