User manual FURUNO FEA-2100 OPERATORS MANUAL

[. . . ] The menu appears in the Information area at the right side of the screen. Rotate the trackball to place the cursor (arrow mark) on [SENC Convert Settings] and press the [SELECT] key. The [SENC Convert Settings] window appears. [SENC Convent Settings] 1 [Close] button 3. [. . . ] Note: We recommend that you check off the [Overview] check box in the [Navigation purpose]. This will omit the loading of the zoomed-out charts, which are normally not used and the ECDIS has already installed these types of chart (7C type). Conversion time can be reduced by not loading the "Overview" charts. [CD] Choose catalogue name. 5. Using the [ZOOM IN], [ZOOM OUT] or [SET CHART CENTER] key, adjust the catalogue chart scale so that you can see all charts desired. 4 6. Place the cursor on the [Groups] button at the bottom of the [Catalogue] window and press the [SELECT] key. [Groups] button [Catalogue] window b. Place the cursor on the [New] button and press the [SELECT] key. [NEW] button c. Place the cursor on an alphbet or number button and press the [SELECT] key. Place the cursor on the [OK] button and press the [SELECT] key. Enter group name. [OK] button 5 e. f. Place the cursor on the [Add Frame] button and press the [SELECT] key. Rotate the trackball to place the cursor inside the chart cell frame desired and press the [SELECT] key. After selecting all areas desired, place the cursor on the [DONE] button and press the [SELECT] key. [Done] button [Group] window [Save] button [Inside] [Close] button h. Confirm that the chart numbers selected are shown in the [Inside] box in the [Group] window and then place the cursor on the [Save] button and press the [SELECT] key. Place the cursor on the [Close] button and press the [SELECT] key to close the [Group] window. 6 4. Chart Conversion (from ENC format to SENC format) The chart data in a CD-ROM (ENC format) must be converted to SENC format in order to display it on the ECDIS. Place the cursor on [Load] - [View loaded CD Catalogue] and press the [SELECT] key. [Load] [View loaded CD Catalogue] [Group Select] window [CD] box 3. Place the cursor on the [Groups] button in the [Chart Selection] window and press the [SELECT] key. Place the cursor on the catalogue name entered at the [Group Select] window and press the [SELECT] key. The chart numbers chosen above are displayed in black as shown in the left figure. [OK] button [Groups] box Group name ebtered. [. . . ] The conversion may take 4 - 5 hours, depending on the quantity of chart numbers [SENC CONVERT] window installed. 9 The error message may appear during conversion, however leave the message displayed until the conversion is completed. [Error] The list in the [Conversion List] becomes blank after conversion is completed. Place the cursor on the [Close] button of the [SENC CONVERT], [Failed SENC conversions] and [Catalogue] and press the [SELECT] key to close the windows. The message [FAIL CONVERSION] may appear List becomes blank after conversion is completed. [. . . ]