User manual FUNAI F260LC

[. . . ] If you need additional operating assistance after reading this owner's manual or to order replacement accessories, please call TOLL FREE : 1-800-242-7158. The lightning flash with arrowhead symbol, within an equilateral triangle, is intended to alert the user to the presence of uninsulated "dangerous voltage" within the product's enclosure that may be of sufficient magnitude to constitute a risk of electric shock to persons. Read Instructions- All the safety and operating instructions should be read before the appliance is operated. Retain Instructions- The safety and operating instructions should be retained for future reference. [. . . ] To use the VCR with your TV, set the selector switch to CH3 or CH4 (which is located in the back of your VCR), whichever is not CH3 CH4 used for normal broadcasts in your area. You can automatically program the tuner to scan only the channels you receive in your area. ⷠChannel memory programming is NOT needed when you connected the VCR to a cable box or satellite box as in "Connect VCR to TV". In this case, select the VCR and TV to channel 3 or 4 the same channel as the CH3 or CH4 switch on the back of the VCR. Then, the channel you want to record or view may be selected at the cable box or satellite box. Repeat it only if there is a power failure or if the VCR is unplugged for more than 30 seconds. ) · You must follow the steps below before attempting to play or record a video tape. If you want to play or record a video tape BEFORE programming the tuner, you can cancel it by pressing [EXIT/RESET]. You can select the desired channel by using [CHANNEL ( ) ] or directly pressing [Number] on the remote control. note for using the Number buttons: · When selecting cable channels which are higher than 99, press [+100] first, then press the last two digits. ⷠYou must precede single-digit channel numbers with a zero (For example: 02, 03, 04 and so on). Now set the CH3/CH4 switch on the back of the VCR to match the channel selected on the TV. Now set the CH3/CH4 switch on the back of the VCR to match the channel selected on the TV. When a tape has reached the end, the VCR will rewind the tape to the beginning, eject the tape, and turn off the VCR automatically. ⷠS-VHS Quasi Playback (SQPB): This unit allows you to view a tape recorded in S-VHS format. When the VCR automatically program the tuner to scan only the channels you receive in your area, some channels may be skipped due to weak signal. You can freeze the picture on TV screen by pressing [PAUSE/STILL] during playback. ⷠYou can advance the picture by one frame at a time by pressing [PAUSE/STILL] during the still mode. ⷠIf the picture begins to vibrate vertically during the still mode, stabilize the picture by pressing ) ]. [CHANNEL ( · If the picture is distorted or rolling vertically, adjust the vertical hold control on your TV, if equipped. You can see the slow motion by pressing [SLOW] during playback or the still mode. ⷠIf the noise bar appears on the TV screen, you can ) ]. [. . . ] Should your VCR become inoperative, do not try to correct the problem by yourself. Turn off, unplug the power plug, and please call our help line at Automatically cleans video heads as you insert or remove a cassette, so you can see a clear picture. ⷠPlayback picture may become blurred or interrupted while the TV program reception is clear. Dirt accumulated on the video heads after long periods of use, or the usage of rental or worn tapes can cause this problem. [. . . ]