User manual FUNAI 4800Z

[. . . ] If the provided plug does not fit into your outlet, consult an electrician for replacement of the obsolete outlet. Protect the power cord from being walked on or pinched particularly at plugs, convenience receptacles, and the point where they exit from the apparatus. Use only with the cart, stand, tripod, bracket, or table specified by the manufacturer, or sold with the apparatus. When a cart is used, use caution when moving the cart/apparatus combination to avoid injury from tip-over. [. . . ] The procedure described here is for the remote control, however the POWER, INPUT SELECT and VOLUME buttons on the plasma display can also be used in the same way. If you turn the audio mute on, a message slowly flashes on the screen. The power turns ON and the POWER indicator on the main unit turns green. It takes approximately 8 seconds for the screen to display after turning the power ON, but this is not a malfunction. To turn the audio mute off, either press the MUTE button again or press the VOL K / L button. â· If you press either the PREVIOUS, K, L, B or { button in a mode apart from the image adjustment mode. The POWER indicator on the main unit turns blue and the STANDBY indicator lights up. Each time you switch the input, the name of the selected input terminal is displayed on the screen for approximately 4 seconds. "No signal" is displayed on the screen if there is no input from the selected terminal and there is no message currently displayed on the screen for volume adjustment or the setup menu, etc. â· If there is no video signal and there has been no operation from the remote control or the buttons on the main unit for more than 15 minutes, the auto shut-off function activates and the display switches to standby mode. You cannot turn the power ON for approximately 3 seconds after the power enters the standby mode. Use this mode to view letterboxed 4:3 picture content to get a widescreen picture. When the still mode is on, the message "Still" slowly flashes on the screen. You cannot turn the still mode on when there is no video signal or when switching between video signals. You can also press the INPUT SELECT, DISPLAY, SLEEP, VOL K(up) / L(down), MUTE, SCREEN MODE or MENU buttons to turn the still mode off. The timer starts counting down after the message displaying the set time disappears (after approximately 4 seconds). The remaining time displayed for the sleep timer changes in steps of 1 minute. In the setup menu, you can specify settings for picture adjustment, picture position, language, screen saver and background. If you do not press any buttons for approximately 20 seconds, the display automatically exits the menu mode. Picture select display will disappear from the TV screen automatically after about 20 seconds if you do not press any buttons. Select the automatic adjustment mode according to the type of picture displayed on the screen with the { / B buttons. If you have selected Brightness, Contrast, Color, Tint or Sharpness, the menu display disappears, and a bar for adjusting the selected mode appears in the center of the bottom of the screen. [. . . ] changing the direction or position of the antenna may improve reception. Ghosting may also be caused by defects in the antenna system such as unshielded leads or connecting several sets to the same antenna without using multiple antenna couplers. Ghosting occurring when the plasma display is connected to a cable TV system may indicate a bad cable wire or loose connection. SNOW: If your receiver is located in the fringe area of a television station where the signal is weak, your picture may be marred by the appearance of small dots. [. . . ]