User manual FUNAI 3909CLC

[. . . ] Ventilation- Slots and openings in the cabinet are provided for ventilation and to ensure reliable operation of the video product and to protect it from overheating, and these openings must not be blocked or covered. The openings should never be blocked by placing the video product on a bed, sofa, rug, or other similar surface. This video product should not be placed in a built-in installation such as a bookcase or rack unless proper ventilation is provided or the manufacturer's instructions have been adhered to . Power Sources- This video product should be operated only from the type of power source indicated on the marking label. [. . . ] Damage Requiring Service- Unplug this video product from the wall outlet and refer servicing to qualified service personnel under the following conditions: a. If the video product does not operate normally by following the operating instructions. Adjust only those controls that are covered by the operating instructions as an improper adjustment of other controls may result in damage and will often require extensive work by a qualified technician to restore the video product to its normal operation. When the video product exhibits a distinct change in performance-this indicates a need for service. Replacement Parts- When replacement parts are required, be sure the service technician has used replacement parts specified by the manufacturer or have the same characteristics as the original part. Unauthorized substitutions may result in fire, electric shock or other hazards. Safety Check- Upon completion of any service or repairs to this video product, ask the service technician to perform safety checks to determine that the video product is in proper operating condition. Heat- This video product should be situated away from heat sources such as radiators, heat registers, stoves, or other products (including amplifiers) that produce heat. For safety and optimum performance of your VCP: · install the VCP in a horizontal and stable position. Shield it from direct sunlight and keep it away from sources of intense heat. Avoid places with insufficient ventilation for proper heat dissipation. Jack of "Remote Control Sensor Wire" box (not supplied) when the VCP locates remote cargo area or behind rear seat. Instead of firing at the VCP, you can control its function by locating "Remote Control Sensor Wire" box where it is accessible to signal from remote control unit. *You can't use the remote sensor on the front panel of the VCP when this jack is occupied. If your TV does not have A/V terminals: When the VCP is in the Playback mode, your TV will receive signals from the VCP on either channel 3 or 4. To use the VCP with your TV, set the selector switch to CH3 or CH4 (which is located in the back of your VCP), whichever is not used for normal broadcasts in your area. Instead of firing at the VCP, you can control its function using remote control sensor on your TV (Funai TV). *You can't use the remote sensor on the front panel of VCP when this jack is occupied. *When you connect both REMOTE CONTROL jack and TV REMOTE LINK jack at the same time, REMOTE CONTROL jack takes precedence over the TV REMOTE LINK jack. Now set the CH3/CH4 switch on the back of the VCP to match the channel selected on the TV. When a tape has reached the end, the VCP will rewind the tape to the beginning, eject the tape, and turn off the VCP automatically. This function enables you to improve the picture quality when playing back worn cassettes such as rented tapes. [. . . ] ⷠIf the picture begins to vibrate vertically during the still mode, stabilize the picture by pressing [TRACKING This VCP can playback Hi-Fi stereo sound. If you play non-Hi-Fi tapes, the VCP will play automatically In monaural even if you select one of these mode. If you have followed the instructions contained in this manual and have difficulty in operating your VCP, locate the PROBLEM in the left column below. TV programs cannot be seen · Make sure the power plug is connected to an AC outlet. [. . . ]