User manual FUJITSU P1035

[. . . ] B5FH-4881-01EN-00. book Page 1 Thursday, January 17, 2002 10:43 AM Copyright Copyright Fujitsu PC Corporation has made every effort to ensure the accuracy and completeness of this document. However, as ongoing development efforts are continually improving the capabilities of our products, we cannot guarantee the accuracy of the contents of this document. Fujitsu, the Fujitsu logo, and LifeBook are registered trademarks of Fujitsu Limited. The following are registered trademarks of IBM Corporation: IBM, IBM PC AT, IBM PS/2. [. . . ] Adjust the sound volume control settings in your software, operating system and applications. Plugging in headphones disables the built-in speakers, remove the headphones. Refer to your application and operating system documentation for help. The software volume control is set too low. The setup utility is incorrectly set for your internal (Primary Master) or optional second hard drive (Primary Slave). The wrong drive designator was used by an application when a bootable CD-ROM was used to start the notebook. Security is set so your operating system cannot be started without a password. Keyboard or Mouse Problems The built-in keyboard does not seem to work. The notebook has gone into Suspend mode. Eject the floppy disk and set it to write enable. (See Preparing a Disk for Use on page 44 for more information) Eject floppy disk, check orientation and re-insert. (See Ejecting a Disk on page 44 for more information) Remove and re-install your floppy disk drive. Verify your password and security settings. Revise BIOS settings to set both Primary Master and Primary Slave correctly. (See BIOS Setup Utility on page 23 for more information) Verify drive designator used by application is in use by the operating system. When the operating system is booted from a CD, drive designations are automatically adjusted. Verify your password and security settings. Push the Suspend/Resume/Power On button. 40 B5FH-4881-01EN-00. book Page 41 Thursday, January 17, 2002 10:43 AM Tro ublesho oting Problem Possible Cause Possible Solutions The built-in keyboard does not seem to work. (continued) You have installed an external keyboard or mouse, and it does not seem to work. Your application has locked out your keyboard. Try to use your integrated pointing device to restart your system. If this fails, turn your system off using the Power Off button located on the back of the system. (See Device Ports on page 35 for more information) Check your device and operating system docu-mentation and activate the proper driver. Check your device and operating system documentation and activate the proper driver. Your external device is not properly installed. The operating system software is not set up with the correct software driver for that device. Your operating system software is not setup with the correct software driver for that device. This happens due to the design specifications of the Quick Point device. You have connected an external keyboard or a mouse and it seems to be locking up the system. When the system is slightly inclined and the QuickPoint device has been worked with slowly for several seconds, the cursor slowly moves across the screen when you are not using it. [. . . ] The termination on a loop may consist of any combination of devices such that the total of the load numbers of all devices does not exceed 100. CAUTION For safety, users should ensure that the electrical ground of the power utility, the telephone lines and the metallic water pipes are connected together. Users should NOT attempt to make such connections themselves but should contact the appropriate electric inspection authority or electrician. This may be particularly important in rural areas. 68 Avis Aux Utilisateurs Du Réseau Téléphonique Canadien L'étiquette canadienne Industrie Canada identifie l'équipement certifié. [. . . ]