User manual FUJITSU LIFEBOOK N6420

[. . . ] N6420. book Page 1 Friday, September 22, 2006 4:28 PM Copyright Fujitsu LifeBook N6420 Notebook ® User's Guide N6420. book Page 2 Friday, September 22, 2006 4:28 PM Copyright N6420. book Page 3 Friday, September 22, 2006 4:28 PM Copyright Copyright and Trademark Information Fujitsu Computer Systems Corporation has made every effort to ensure the accuracy and completeness of this document. However, as ongoing development efforts are continually improving the capabilities of our products, we cannot guarantee the accuracy of the contents of this document. The absence of a product or service name, slogan, or logo does not constitute a waiver of any trademark or other intellectual property rights relating to that name, slogan, or logo owned by Fujitsu Computer Systems Corporation, its parent, subsidiaries, and affiliated companies. Fujitsu, the Fujitsu logo, and LifeBook are registered trademarks of Fujitsu Limited. [. . . ] This means that the floppy disk drive type identified in your setup utility does not agree with the type detected by the Power On Self Test. In the unlikely case that you see this message you may have some display problems. You can continue operating but should contact your support representative for more information. You may have to replace your keyboard or keyboard controller but may be able to use an external keyboard until then. You may have to replace your keyboard or keyboard controller but may be able to use an external keyboard until then. *Keyboard error nn BIOS discovered a stuck key and displays the scan code for the stuck key. You may have to replace your keyboard but may be able to use an external keyboard until then. *Monitor type does not match CMOS ­ Run SETUP Monitor type not correctly identified in Setup. This error probably means your BIOS is corrupted, run the setup utility and set all settings to the default conditions. #*Operating system not found Operating system cannot be located on either drive A: or drive C:. Enter the setup utility and see if both the fixed disk, and drive A: are properly identified and that the boot sequence is set correctly. Unless you have changed your installation greatly, the operating system should be on drive C:. If the setup utility is correctly set, your hard drive may be corrupted and your system may have to be reinstalled from your back up media. Contact your support representative. 63 N6420. book Page 64 Friday, September 22, 2006 4:28 PM LifeBook N6400 Series User's Guide *Parity Check 2 nnnn Parity error found in the I/O bus. #*Press <F1> to resume, <F2> to SETUP Displayed after any recoverable error message. Press the [F1] key to continue the boot process or the [F2] key to enter Setup and change any settings. #*Previous boot incomplete ­ Default configuration used Previous Power On Self Test did not complete successfully. The Power On Self Test will load default values and offer to run Setup. If the previous failure was caused by incorrect values and they are not corrected, the next boot will likely fail also. If using the default settings does not allow you to complete a successful boot sequence, you should turn off the power with the power/suspend/ resume button and contact your support representative. *Shadow RAM Failed at offset: nnnn Shadow RAM failed at offset nnnn of the 64k block at which the error was detected. nnnn Shadow RAM Passed Where nnnn is the amount of shadow RAM in kilobytes successfully tested. [. . . ] The first option, Automatically log on to OmniPass as the current user, will do just as it says; during Windows login, you will be logged on to OmniPass using your Windows login credentials. If the user logging into Windows was never enrolled into OmniPass, upon login no one will be logged on to OmniPass. This setting is appropriate for an office setting or any setting where users must enter a username and password to log into a computer. With the second option, Manually log on to OmniPass at startup, OmniPass will prompt you to login once you have logged on to Windows. [. . . ]