User manual FUJITSU C2220

[. . . ] Brie3-B5FH-8711. book Page 1 Wednesday, May 14, 2003 10:37 AM Copyright Copyright Fujitsu PC Corporation has made every effort to ensure the accuracy and completeness of this document. However, as ongoing development efforts are continually improving the capabilities of our products, we cannot guarantee the accuracy of the contents of this document. Fujitsu, the Fujitsu logo, and LifeBook are registered trademarks of Fujitsu Limited. The following are registered trademarks of Microsoft Corporation: MS, MS-DOS, Windows. [. . . ] In ad hoc mode, the WEP key must be entered identically on each computer. a. Check the [Data encryption (WEP enabled)] check box For ad hoc connection: Clear the check mark from the [Network Authentication (Shared mode)] check box. For infrastructure connection: If the access point to be accessed has acquired shared-key authentication, check the [Network Authentication (Shared mode)] check box. 56 Brie3-B5FH-8711. book Page 57 Wednesday, May 14, 2003 10:37 AM Using the WIreless LAN 13. Verify that the network name entered in step 7 above is added in [Preferred Networks], and then click the [OK] button. POINT In [Preferred Networks], register only the desired connection settings. For infrastructure connection: If your network uses DHCP, select [Obtain an IP address automatically] and [Obtain DNS server address automatically]. If your network uses static IP addresses, consult with your network administrator for the correct IP address settings. 8. Processing will return to the [Wireless Network Connection Properties] window. Following this operation, confirm the names of the computer and the workgroup as follows. Confirming the computer and work group names POINT To modify the computer name and/or the work group name, you need to be logged in from Windows as an administrator. 14. Close the [Wireless Network] window. CONNECTION TO THE NETWORK This section explains connection to the network. If there is an administrator of the network, contact the network administrator for data settings. Setting the network Perform the "Setting TCP/IP" and "Confirming the computer and work group names" operations required for network connection. POINT To change the setting of the IP address, you need to be logged in from Windows as an administrator. Click the [Start] button, then [Control Panel]. If the Control Panel is in Category view, switch to Classic view by clicking "Switch to Classic View" under Control Panel the left frame. (If you are already in Classic view, "Switch to Category View" will be displayed. ) Double-click the [System] icon. The setting of [Full computer name:] denotes the name for identifying the computer. If the Control Panel is in Category view, switch to Classic view by clicking "Switch to Classic View" under Control Panel the left frame. (If you are already in Classic view, "Switch to Category View" will be displayed. ) Double-click [Network Connections]. Right-click [Wireless Network Connection] in the list, and then click [Properties] in the menu displayed. The [Wireless Network Connection Properties] window will be displayed. 6. To change the name, click [Change] and then proceed in accordance with the instruction messages displayed on the screen. 7. For ad hoc connection: Select [Use the following IP address:] and then enter data for [IP address] and [Subnet mask]. See page 70 for IP address setting. Enter the desired name in less than 15 ASCII character code format. [. . . ] Status Indicator A display which reports the condition of some portion of your hardware. On your LifeBook notebook this is an LCD screen just above the keyboard. Stereo (audio) A system using two channels to process sound from two different sources. Stroke (keyboard) The amount of travel of a key when it is pressed from resting to fully depressed. [. . . ]