User manual FUJITSU C1320D

[. . . ] cotton. book Page 1 Wednesday, August 17, 2005 1:20 PM Copyright Copyright and Trademark Information Fujitsu Computer Systems Corporation has made every effort to ensure the accuracy and completeness of this document; however, as ongoing development efforts are continually improving the capabilities of our products, we cannot guarantee the accuracy of the contents of this document. Fujitsu, the Fujitsu logo, and LifeBook are registered trademarks of Fujitsu Limited. MS, MS-DOS, and Windows are either registered trademarks or trademarks of Microsoft Corporation in the United States and/or other countries. ExpressCardTM Compliance ID Number: EC100034 The ExpressCard word mark and logo are owned by the Personal Computer Memory Card International Association (PCMCIA) and any use of such marks by Fujitsu Computer Systems Corporation is under license. [. . . ] LifeBook notebook does not turn on when installed in the optional Port Replicator Floppy Disk Drive Problems You cannot access your floppy disk. The wrong drive designator was used by an application when a bootable CD-ROM was used to start the notebook. Security is set in the BIOS so your operating system cannot be started without a password. Keyboard or Mouse Problems The built-in keyboard does not seem to work. You have installed an external keyboard or mouse, and it does not seem to work. (See Device Ports on page 44 for more information) Verify drive designator used by application is in use by the operating system. When the operating system is booted from a CD, drive designations are automatically adjusted. (See Preparing a Disk for Use on page 38 for more information) Eject floppy disk, check orientation and re-insert. (See Ejecting a Disk on page 38 for more information) Remove and re-install your floppy disk drive. Remove and re-dock your LifeBook notebook. 51 cotton. book Page 52 Wednesday, August 17, 2005 1:20 PM LifeBook C Series Notebook - Section Five Problem Possible Cause Possible Solutions You have installed an external keyboard or mouse, and it does not seem to work. (continued) Your operating system software is not set up with correct software driver for that device. Your mouse or keyboard is connected to the wrong PS/2 port on the optional Port Replicator. Your operating system software is not setup with correct software driver for that device. Your system has crashed. Check your device and operating system documentation and activate the proper driver. Plug the mouse into the PS/2 Mouse port and the external keyboard into the PS/2 Keyboard port. (See Docking Port on page 45 for more information) Check your device and operating system documentation and activate the proper driver. I You have connected an external keyboard or a mouse and it seems to be locking up the system. Memory Problems Your Power On screen, or Main menu of the BIOS setup utility information, does not show the correct amount of installed memory. Modem Problems Messages about modem operation. Your memory upgrade module is not properly installed. You have a memory failure. Remove and re-install your memory upgrade module. (See Memory Upgrade Module on page 42 for more information) Check for Power On Self Test (POST) messages. (See Power On Self Test Messages on page 58 for more information) Messages about modem operation are generated by whichever modem application is in use. See your application software documentation for additional information. Parallel, Serial, and USB Device Problems You have installed a parallel port device, a serial port device or a USB device. [. . . ] Shared key authentication is not considered secure, because a hacker who detects both the clear-text challenge and the same challenge encrypted with a WEP key can decipher the WEP key. SSID (Service Set Identifier) Service Set Identifier, a 32-character unique identifier attached to the header of packets sent over a WLAN that acts as a password when a mobile device tries to connect to the BSS. The SSID differentiates one WLAN from another, so all access points and all devices attempting to connect to a specific WLAN must use the same SSID. A device will not be permitted to join the BSS unless it can provide the unique SSID. [. . . ]