User manual FUJITSU 790TX

[. . . ] COPYRIGHT Fujitsu PC Corporation has made every effort to ensure the accuracy and completeness of this document. However, as ongoing development efforts are continually improving the capabilities of our products, we cannot guarantee the accuracy of the contents of this document. Fujitsu and the Fujitsu logo are registered trademarks and LifeBook is a trademark of Fujitsu Limited. Built for Humans and ErgoTrac are trademarks of Fujitsu PC Corporation. [. . . ] (See page 57. ) Table 3-10 shows the names of the menu fields for the IRQ Reservation submenu of the PCI Configuration submenu, all of the options for each field, the default settings and a description of the field's function and any special information needed to help understand the field's use. Figure 3-10 IRQ Reservation Submenu 83 Section Three Table 3-10 Fields, Options and Defaults for the IRQ Reservation Submenu of the of the PCI Configuration Submenu of the Advanced Menu Menu Field Options Default Description IRQ 3: Available; Reserved. If Reserved is selected, the BIOS reserves IRQ 3 for use by legacy ISA devices and does not use it for embedded PCI or ISA devices. IRQ 3 is removed from the IRQ bitmap in the PCI IRQ routing table. CAUTION Only IRQ's 9, 10, & 11 can be reserved without conflict. IRQ 4: IRQ 5: IRQ 7: IRQ 9: IRQ 10: IRQ 11: Available; Reserved. Available; Reserved. [Available] [Available] [Available] [Available] [Available] [Available] 84 LifeB ook 70 0 Series from Fuj itsu C onfi gu ri n g Your Li fe Book 700 S er ie s DMI Event Logging Submenu of the Advanced Menu The DMI Event Logging Submenu is for setting up the logs DMI event logging. Follow the instructions for Navigating Through the Setup Utility to make any changes. (See page 57. ) Table 3-11 shows the names of the menu fields for the DMI Event Logging submenu, all the options for each field, the default settings and a description of the field's function and any special information needed to help understand the field's use. Figure 3-11 DMI Event Logging Submenu 85 Section Three Table 3-11 Fields, options and Defaults for the DMI Event Logging Submenu Menu Field Event log capacity: Event log validity: Clear all DMI event logs: Options Display only. Default [Space Available] [Valid] [No] A Yes selection causes the event logs to clear at the next boot. Once the logs are cleared this automatically sets to No until reset to yes by selecting yes here. Description Event Logging: System Boot Event: Enabled; Disabled. Enabled; Disabled. [Enabled] [Disabled] 86 LifeB ook 70 0 Series from Fuj itsu C onfi gu ri n g Your Li fe Book 700 S er ie s ACPI Features Submenu of the Advanced Menu The ACPI Features Submenu is for setting up the Windows 95 Advanced Configuration and Power Interface parameters. Follow the instructions for Navigating Through the Setup Utility to make any changes. (See page 57. ) Table 3-12 shows the names of the menu fields for the ACPI Features submenu, all the options for each field, the default settings and a description of the field's function and any special information needed to help understand the field's use. Figure 3-12 ACPI Features Submenu 87 Section Three Table 3-12 Fields, options and Defaults for the ACPI Features Submenu Menu Field Enable ACPI: Options Yes; No. Default [Yes] Description Turns on and off the Advanced Configuration and Power Interface. Exiting from the Advanced Menu When you have finished setting the parame ters on the Advanced Menu, you can either exit from setup utility or move to another menu. If you wish to exit fr om setup utility, press the Esc key to go to the Exit me nu. If you wish to move to another menu, use the cursor keys. 88 LifeB ook 70 0 Series from Fuj itsu C onfi gu ri n g Your Li fe Book 700 S er ie s SECURITY MENU ­ SETTING THE SECURITY FEATURES The Security menu allows you to set up the data security features of your notebook to fit your operating needs and to view the current data security configuration. Follow the instructions for Navigating Through the Setup Utility to make any changes. (See page 57. ) Table 3-13 shows the names of the menu fields for the Security menu, all of the options for each field, the default settings and a description of the field's function and any special information needed to help understand the field's use. The default condition is no passwords required and no write protection. Figure 3-13 Security Menu 89 Section Three POINT If you set a password, write it down and keep it in a safe place. If you forget the password you will have to contact your support representative to regain access to your secured functions and data. CAUTION Entering a password incorrectly 3 times in a row will cause the keyboard and mouse to be locked out and the warning [System Disabled] to be displayed. If this happens restart the computer by turning off and on the power with the power switch and use the correct password on reboot. POINT If you make an error when re-entering the password a [Warning] will be displayed on the screen. Press the Esc key to abort the password setting process. CAUTION If the Power Management Security is Enabled and the Password on Boot is Disabled you will not be able to resume operation from the Suspend or Save-toDisk modes. 90 LifeB ook 70 0 Series from Fuj itsu C onfi gu ri n g Your Li fe Book 700 S er ie s Table 3-13 Fields, Options and Defaults for the Security Menu Menu Field Supervisor Password is: User Password is: Set Supervisor Password: Options -- -- [Enter] Default Clear Clear -- Description A display-only field. [. . . ] 2, 4, 7-8, 17, 19-22, 26-27, 36-37, 50-51, 55, 62, 106, 116-118, 120-121, 139-141 143, 161-162, 168, 172 holder tray . 7, 12-13, 38-42, 44, 46, 48, 53-55, 57, 70, 91, 106, 140, 144, 153-154, 161 Block addressing . . 53-54, 64, 138, 153-154, 159 LifeB ook 70 0 Series from Fuj itsu Index Cigarette lighter . 8-9, 34, 52, 54, 74, 116, 123, 128, 132, 136, 168-169, 172-173, 175 External monitor. [. . . ]