User manual FUJITSU SIEMENS STORAGEBIRD SOLO 25-UP

[. . . ] All rights, including rights created by patent grant or registration of a utility model or design, are reserved. The STORAGEBIRD is a Plug&Play device - simply connect it to your computer with the supplied USB cable. An external power supply is only needed if the STORAGEBIRD is connected to a USB hub without a power supply, or to a system with insufficient power on the USB cable. [. . . ] Depending on the model you have purchased, an external power supply is provided, or you can purchase a suitable power supply as an accessory. Your device is partitioned into two drives which are denoted as the "AP" and "public" drives in Windows Explorer. The "public" drive is not encrypted and can be used without registration. Firmly run the selected finger at least three times over the fingerprint sensor of your device. After successful registration of the finger, the Fingerprint Registration selection window reappears. Left-click on the FingerVerify application in the symbol area of your task bar. Follow the instructions given in the chapter "Registration of a fingerprint under Windows ", Page 4. Left-click on the FingerVerify application in the symbol area of your task bar. Enable box 1 if a password hint should be displayed for every password entry. Enable box 3 if you would like only your fingerprint to be used for verification of your identity. Enable box 4 if you would like only your password to be used for verification of your identity. Enable box 8 if the FingerVerify functionality should be protected by the password. After several unsuccessful attempts you must enter the password which you assigned at registration. Before removing your device from the USB port or shutting down and/or restarting your computer, you must close the FingerVerify programme in your desktop task bar. Right-click on the FingerVerify application in the symbol area of your task bar. Follow the instructions given in chapter "Removal under Windows XP / Windows Vista", Page 8 to remove the device from the USB port of your computer. You can deactivate a "USB mass storage device" using the corresponding taskbar button. Cause If you attempt to copy more than 4 GB of data to the device then Microsoft Windows will abort the process and display an error message. [. . . ] The Safely Remove Hardware function does not Close all programs that might access the work. You can install it whenever you like - even while the computer is switched on. Port Transfer rate Operating system Data transfer indication Power supply External power supply Dimensions (LxWxH) Weight Backup key USB 2. [. . . ]