User manual FUJITSU SIEMENS LIFEBOOK 544

[. . . ] Operating Manual System LIFEBOOK A544 LIFEBOOK AH544 LIFEBOOK AH564 Congratulations on your purchase of an innovative product from Fujitsu. Com/download" Should you have any technical questions, please contact: • our Hotline/Service Desk (see the Service Desk list or visit: "http://support. Com/contact/servicedesk") • Your sales partner • Your sales office We hope you enjoy working with your new Fujitsu system!Published by / Contact address in the EU Fujitsu Technology Solutions GmbH Mies-van-der-Rohe-Straße 8 80807 Munich, Germany "http://www. [. . . ] Userpassword Supervisor Password password Fujitsu 41 Security functions Changing the supervisor or user password You can only change the supervisor password when you have logged into the BIOS Setup Utility with the supervisor password. User password Supervisorpassword Password ► Call the BIOS Setup Utility and go to the Security menu. – When changing the password, proceed exactly as for password assignment. Removing passwords To remove a password (without setting a new password) perform the following steps: User password Supervisorpassword Password ► Start the BIOS Setup Utility and go to the Security menu. – Highlight the Set Supervisor Password or Set User Password field and press the Enter key. You will be requested to enter the current password by the Enter Current Password prompt. You will be requested to enter a new password by the Enter New Password prompt. Removing the supervisor password simultaneously deactivates the user password. Password protection for booting of the operating system With the supervisor password you have set in the BIOS Setup Utility (see section "Setting supervisor and user password", Page 41), you can also prevent booting of the operating system. Operating system Activating system protection ► ► ► ► Operatingsystem Start the BIOS Setup Utility and go to the Security menu. Select the desired option (Disabled, First Boot or Every Boot) and press the Enter key Select the Save Changes & Exit option under Exit. You will be prompted to enter your password (the supervisor password). Deactivating system protection ► Start the BIOS Setup Utility and go to the Security menu. If you do not want to change any other settings, you can exit BIOS Setup Utility. Operatingsystem 42 Fujitsu Security functions Password protection for the hard disk Passwordprotection: The had disk password prevents unauthorised access to the hard disk drives and is checked internally each time the system is booted. The condition for this is that you have assigned at least the supervisor password. Activating hard disk protection ► Call up the BIOS Setup and select the Security menu. If you have not assigned BIOS passwords yet, define the supervisor and the user password now, if desired (see "Security functions", Page 40). – In the Drive0 area mark the Set Master Password field and press the Enter key. Enter new Password then appears and you are asked to enter a password. Setup Notice: Changes have been saved is displayed to confirm that the new password has been saved. – To assign the password for the second hard disk (Drive1), go to the Drive1 area and select the field Set Master Password, then proceed in exactly the same way as for setting up the password for the first hard disk (Drive0). [. . . ] If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: 1. Connect the equipment to an outlet on a circuit different from the one the receiver is connected to. Please note the following regulatory information related to the optional radio device. FCC Radio Frequency Exposure statement This radio device has been evaluated under FCC Bulletin OET 65C and found compliant with the requirements as set forth in CFR 47 Sections 2. [. . . ]