User manual FUJITSU SIEMENS AMILO DESKTOP SI 3535 FIRST-TIME SETUP

[. . . ] These operating instructions show you amongst other things how to start up and operate your machine. General information on your machine can be found in the "AMILO Desktop" operating instructions. Software-related parts of these instructions refer to Microsoft products, where these are included in the scope of supply of your machine. When installing other software products, refer to the operating instructions issued by the manufacturer. [. . . ] To avoid this, allow a minimum clearance of 3 mm from other equipment or objects at the sides of the casing where there are no ventilation grilles. In order to avoid overheating, do not cover the ventilation area of the monitor or the device. do not expose the device to extreme ambient conditions (see "AMILO Desktop S" , Page 21 , "Ambient conditions"). With the exception of USB devices, always remove all power plugs before connecting external devices!Please make sure that you always observe the safety notes provided in "Important information", Page 3 . Disconnect all of the cables from the device and from the external devices. Follow the instructions contained in the monitor manual to prepare the monitor for operation (e. Depending on the expansion stage of your machine and your monitor, you can also connect the data cable to the DVI interface. The LX300 Wireless Keyboard Set with wireless mouse and keyboard is supplied with your machine. Comply with the safety information in the safety manual and in the operating instructions for the "AMILO Desktop". A symbol in the battery compartment shows you which way round to insert the batteries. To save power, set the on/off switch on the underside of the mouse to "OFF" when you are not going to use the mouse for an extended period. A symbol in the battery compartment shows you which way round to insert the batteries. Move the receiver in the direction of the arrow to take it out of the keyboard. Normally a radio connection code is generated automatically and the Keyboard Set is then immediately ready for operation. When the connection has successfully been established the LED on the receiver lights up green. The LEDs on the keyboard and mouse light up red if the battery voltage falls below 2. If the connection is not established automatically, or if it breaks down, proceed as follows: Unplug the receiver from your computer and plug it in again. Place the mouse at a distance no greater than 30 cm from the receiver. The LED on the receiver will flash green 4 times to indicate that the connection to the mouse has been established successfully. The LED on the receiver will flash green 4 times to indicate that the connection to the keyboard has been established successfully. Skip forward and back buttons on the mouse In addition to the right and left mouse buttons and a mouse wheel, your mouse has two additional buttons (1): These two buttons allow you to skip easily forward and back within an application, e. [. . . ] Card types that can be read without an adapter: · Memory Stick Pro Card types that can be read with an adapter: · MemoryStick Pro Duo Reduced-Size MultiMedia Card (RS-MMC) Mini-SecureDigital Card (Mini SD) Always wait until the data access is completed before removing a card from the slot. When handling memory cards, comply with the manufacturer's instructions. Do not force the card in, otherwise the delicate contact surfaces can be damaged. Taking out the memory card Always wait until the data access is completed before removing a card from the slot. [. . . ]