User manual FUJITSU SIEMENS AMILO DESKTOP PA 3630 FIRST-TIME SETUP

[. . . ] These operating instructions show you amongst other things how to start up and operate your machine. General information on your machine can be found in the "AMILO Desktop" operating instructions. Software-related parts of these instructions refer to Microsoft products, where these are included in the scope of supply of your machine. When installing other software products, refer to the operating instructions issued by the manufacturer. [. . . ] In view of the multitude of different finishes and varnishes used on furniture, it is possible that the rubber feet will mark the surface they stand on. Do not start the machine in any position other than upright on its feet. Depending on the location of your machine, it may emit annoying vibration or noises. To avoid this, allow a minimum clearance of 3 mm from other equipment or objects at the sides of the casing where there are no ventilation grilles. In order to avoid overheating, do not cover the ventilation area of the monitor or the device. do not expose the device to extreme ambient conditions (see "AMILO Desktop L/AMILO Desktop P" , Page 17 , "Ambient conditions"). With the exception of USB devices, always remove all power plugs before connecting external devices!Please make sure that you always observe the safety notes provided in "Important information", Page 3 . Disconnect all of the cables from the device and from the external devices. Follow the instructions contained in the monitor manual to prepare the monitor for operation (e. Depending on the expansion stage of your machine and your monitor, you can also connect the data cable to the DVI interface. A description of these devices can be found in the operating instructions for the "AMILO Desktop". This means you can connect and disconnect USB cables while your device is switched on. Additional information can be found in the documentation for the USB devices. The external USB devices you connect to the USB ports usually require no driver of their own, as the required software is already included in the operating system. However, if the external USB device requires its own software, please install it from the data carrier provided with the USB device. 0, the length of the cable used between the front USB port of your device and the external USB device must not exceed 3 m. If the device is integrated into a network, the user and server details as well as the network protocol are required during the software installation. When you switch on the device for the first time, the supplied software is installed and configured. Plan a reasonable amount of time for this, as this process must not be interrupted. Once the installation has been started the device must not be switched off, unless the installation has been completed. During installation, the device may only be rebooted when you are requested to do so! [. . . ] All other trademarks referenced are trademarks or registered trademarks of their respective owners, whose protected rights are acknowledged. Copyright © Fujitsu Siemens Computers GmbH 2008 All rights reserved, including rights of translation, reproduction by printing, copying or similar methods, either in part or in whole. All rights reserved, including rights created by patent grant or registration of a utility model or design. All other trademarks referenced are trademarks or registered trademarks of their respective owners, whose protected rights are acknowledged. [. . . ]