User manual FRIGIDAIRE FPDS3085K WIRING DIAGRAM REV A

[. . . ] NOTE: Wiring diagram for these appliances are enclosed in this booklet. Do not pinch the power supply cord or the flexible gas conduit between the range and the wall. 24" (61 cm) minimum clearance between the cooktop and the bottom of the cabinet when the bottom of wood or metal cabinet is protected by not less than ¼" (0. Than 30 1/16" (76, 4 cm), make sure the appliance is centered in the counter opening while pushing into it. [. . . ] Cord must have either 3 (when local code permits grounding through neutral) or 4 conductors. Terminal on end of wires must be either closed loop or open spade lug with upturned ends. Do not loosen the nuts which secure the factory-installed range wiring to terminal block while connecting range. Figure 2 This appliance is manufactured with the frame grounded by connection of a grounding strap between the neutral power supply terminal and the frame. If used in USA, in a new branch circuit installation (1996 NEC), mobile home or recreational vehicule, where local code do not permit grounding through neutral (white) wire orinCanada;removethegroundingstrapfrom the frame and cut the other end, near the neutral terminal. Remove the 3 screws at the lower end of the rear wire cover, then bend the lower end of the rear wire cover (access cover) upward to expose range terminal connection block (see Figure 2). Using the nuts supplied in the literature package, connect the neutral of the copper power supply cord to the center silver-colored terminal of the terminal block, and connect the other wires to the outer terminals. Match wires and terminals by color (red wires connected to the right terminal, black wires connected to the left terminal) (see figure 3). Where local codes does NOT permit connection of the frame grounding conductor to the neutral wire of the copper power supply cord (see Figure 4): 1. Remove the 3 screws at the lower end of the rear wire cover, then raise the lower end of the rear wire cover (access cover) upward to expose range terminal connection block (see figure 2). Remove the grounding strap from the terminal block and from the appliance frame. For proper operation, the maximum inlet pressure to the regulator should be no more than 14"(35, 56 cm) of water column pressure (3. (Models with an Electric Oven and a Gas Cooktop) The supply line must be equipped with an approved manual shutoff valve. This valve should be located in the same room as the range and should be in a location that allows ease of opening and closing. once regulator is in place , open the shutoff valve in the gas supply line. After connecting the range to the gas supply, check the system for leaks with a manometer. If a manometer is not available, turn on the gas supply and use a liquid leak detector at all joints and connections to check for leaks. All openings in the wall or floor where the range is to be installed must be sealed. tighten all connections if necessary to prevent gas leakage in the cooktop or supply line. Disconnect this range and its individual shutoff valve from the gas supply piping system during any pressure testing of the system at test pressures greater than 1/2 psig (3. Replace the drawer, close the door and switch on the electrical power and gas to the range. If necessary, raise the unit by lowering the front leveling legs and the back leveling wheels. [. . . ] Adjust flame until you can quickly turn knob from LITE to LOWEST POSITION without extinguishing the flame. However, it is suggested that you verify the operation of the electronic oven controls once more. Bake­After setting the oven to 350°F (177°C) for baking, the lower element in the oven should become red. broil­When the oven is set to BROIL , the upper element in the oven should become red. [. . . ]