User manual FRIEDLAND WIREFREE REMOTE KEYPAD
DON'T FORGET : ALWAYS READ THE USER GUIDE BEFORE BUYING !!!
If this document matches the user guide, instructions manual or user manual, feature sets, schematics you are looking for, download it now. Diplodocs provides you a fast and easy access to the user manual FRIEDLAND WIREFREE REMOTE KEYPAD. We hope that this FRIEDLAND WIREFREE REMOTE KEYPAD user guide will be useful to you.
Manual abstract: user guide FRIEDLAND WIREFREE REMOTE KEYPAD
Detailed instructions for use are in the User's Guide.
[. . . ] Fix the mounting plate to the wall using the screws and wall plugs provided, (a 5mm hole will be required for the wall plugs). Do not over-tighten the fixing screws as this may distort or damage the mounting plate. [. . . ] Note: DO NOT fix the Keypad to metalwork or locate the unit within 1m of metalwork (i. e. radiators, water pipes, etc) as this could affect the radio range of the Keypad. Important: If used with a "Siren Controlled" alarm system (i. e. a system without a separate Control Panel), jumper link P1 located in the top left corner of the PCB must be removed; or If the Keypad is to be used with a Control Panel based system, jumper link P1 must be left in place. Note: The Keypad is supplied with a default User Access Code of: 1 2 3 4. For security reasons, it is recommended that this code is changed to another four digit number which only you and other users of the system know.
Installing and Configuring the Remote Keypad
Ensure that the Control Panel is in Test or Programming Mode, (or that the Siren is in Service Mode for single zone systems without a Control Panel), (refer to "System Installation and Operating Manual").
Testing the Remote Keypad
Ensure that the Solar Siren is in Operating Mode and for Control Panel based systems the Control Panel is in Standby Mode, (refer to "System Installation and Operating Manual"). Press
?
?
?
?
,
to Arm the system.
User Access code
1 4 7 0 2 5 8
ON
3 6 9
AIR
1
2. Press and hold and buttons together, after 2 1 approximately 2 seconds an alarm will be initiated.
2
LO W
BA TT.
3. Press
Fixing Screw Wall Fixing Plate
?
?
?
?
,
to Disarm the system
User Access code
and stop the siren.
Operating the Remote Keypad
Arm:
Press
Changing the User Access Code:
Default Code: 1 2 3 4
?
?
?
?
,
User Access code
When using the Keypad the keys must be pressed firmly and within five seconds of each other. If you make a mistake, wait five seconds and recommence programming from the beginning of the sequence. To change the User Access Code, press the following keys in sequence: 1. ?
, ,
1
for Part-Arm 1 for Part-Arm 2
User Access code
2
User Access code
2. [. . . ] Understandably if the product has not been installed, operated or maintained in accordance with the instructions, has not been used appropriately or if any attempt has been made to rectify, dismantle or alter the product in any way the guarantee will be invalidated. It does not extend to cover consequential loss or damage or installation costs arising from the defective product. [. . . ]
DISCLAIMER TO DOWNLOAD THE USER GUIDE FRIEDLAND WIREFREE REMOTE KEYPAD
Click on "Download the user Manual" at the end of this Contract if you accept its terms, the downloading of the manual FRIEDLAND WIREFREE REMOTE KEYPAD will begin.