User manual FRIEDLAND D918S LIBRA+

[. . . ] This product may be purchased from Connevans Limited secure online store at www. Please use the following instructions to ensure correct installation and use. checking pack contents Unpack your chime kit and identify the following parts: ¬ Chime Chime bracket 2 x fixing screws for chime 2 x wall plugs Before proceeding with the installation, please note the following safety warnings: Always follow the manufacturer's advice when using power tools and wear suitable protective equipment (e. [. . . ] Learn mode To enable your chime to learn the identity of your bell push: ¬ Press the button and keep it pressed. Unlearn procedure If you want to remove a push from the chime's memory: ¬ Press the button and keep it pressed. When the Icon associated with the push to be un-learnt is lit, release the button. ¬ Press and hold down both & buttons, until a `beep' sound is heard. The `Main door' and `Backdoor' icons are usually used for bell pushes. The other icons are intended for use with other compatible devices, such as PIR movement detectors and Telephone ring detector. They can be changed, if required, by opening the sliding window of the chime and gently peeling off the strips. If desired, the strips can be cut into individual icons and fixed to the chime in a different order. Use the Programming procedure to change the icon associated with a push. The Chime can be free standing or wall mounted using the wall bracket provided. If wall mounting is preferred, screw the bracket to the wall (see Fig 5). To hear the chime sounds without operating the bell push, press the button. ¬ The push you are programming has already been learnt by the chime. ¬ If you want to change the icon associated with the push, use the un-learn procedure, then programme the push again. [. . . ] If you require further information about our product, call the Friedland helpline on 01268 563066. Batteries and waste electrical products should not be disposed of with household waste. Novar ED&S hereby declares that this product is in compliance with the essential requirements and other relevant provisions of the Radio and Telecommunications Terminal Equipment (R&TTE) directive, 1999/5/EC. [. . . ]