User manual FREESTYLE SHARK CLASSIC MID

[. . . ] The setting sequence is shown as follows: SECOND S3 S3 S3 12/24H DAY S3 MONTH HOUR S3 MINUTE S3 S3 YEAR LIGHT S1 S3 S2 LIGHT BUTTON: In order to activate the light feature on this display, simply press the light button. The light will remain on for a few seconds after you release your finger. - When setting seconds, pressing S1 while the second digits count between 30 to 59 will reset the second digits to 00 and 1 will be added to the minute digits. On the other hand while second digits small then 30 will reset the second digits to 00 and 1 will not added to the minute digits. [. . . ] There are 2 alarms that work independently presented by A1/A2, alarm number, hours, minutes and status. The alarm sounds for 20 seconds if the alarm function is "on". If the chime function is "on", the product will be button confirmation sound. If 24-hour display format is selected for time mode, there is no PM symbol "PM" for alarm time. If there is no button operation for 2-3 minutes in setting mode, the display will return back to Alarm mode automatically. HOW TO USE CHRONOGRAPH Reset Run Split HOW TO USE TIMER R 1 sec auto R R press S1 to start S1 R R Stop Start S1 BASIC OPERATION OF BUTTONS S1: - Forward selection of data number - start/stop chronograph - toggle alarm on or off S2: - Split/ reset chronograph - Select alarm 1 or alarm 2 S3: - Mode change - Select setting (set or calibration) S4: - Back light - Enter setting mode (press and hold) - Exit (setting mode) MODE CHANGE OPERATION The mode change sequence is shown as follows: TIME S3 DATE S3 ALARM CHRONOGRAPH TIMER S3 S3 S3 15 sec - Press S1 to start the Timer. - Press and hold S4 for 3 seconds to enter setting mode, the second digits start flashing. - Press S3 to select the next digits or Counter Repeat, Counter Stop for setting. The setting sequence is shown as follows: S3 SECOND S3 MINUTE S3 HOUR S3 Counter Repeat S1 Counter Repeat S3 Auto count-down R R S1 R R S1 auto Hold S2 for 2 seconds until the user to stop. R R aut R R Chime icon Alarm icon - Press S1 to start the chronograph. - For the first hour, minutes, seconds and 1/100 second are displayed. The chronograph is of 1/100second resolution for first hour and 1-second resolution for the reset and with working range up to 24 hours, then the chronograph stops automatically. - After all adjustments are complete, press S4 to exit setting mode. HOW TO RESET THE DISPLAY Press and hold S1, S2, S3 buttons simultaneously, all segments will be "on", then release the buttons and the display will be reset. After reset, test patterns will be shown for a few seconds and finally the display will be as follows: HOW TO USE TIME MODES - For Time display format, "AL" label marks are displayed at the left row. Default the Year is on 2002 BATTERY REPLACEMENT Replace the exhausted battery with a CR1220 cell or equivalent. [. . . ] Neither this warranty, nor any other warranty expressed, is assumed for any incidental or consequential damages, including but not limited to the mathematical accuracy of the product. Some states do not allow limitations on how long an implied warranty lasts, or the exclusions of or limitations on consequential damages, so the above limitations may not apply to you. This warranty gives you specific legal rights, and you may have other rights which vary from state to state. [. . . ]